SYNCHRONIZED DANCE MUSIC PLAYER
Frederic Chopin, Nocturne
11. Johann Strauss 2：
12. Chopin Etudes Op. 10, No.3
13. Torna a Surriento
W.A.Mozart, Eine kleine
15. Old Folks at Home
16. Santa Lucia
17. Wiegenlied Schubert
Recuerdos de la Alhambra
18. Red Sails In The Sunset
Comin' Thro' the Rye
19. Oh! Susanna
20. Russian folk dance
"Kalinka" and "Troika"
Rhythm Pattern List
修理、 および商品のお取り扱いについてのご質問、 ご相談は、
受付時間 月曜～金曜 10:00 ～ 17:00 （祝祭日、 窓口休業日を除く）
〒168-0073 東京都杉並区下高井戸1-18-16 2F
2. 保証書は再発行致しませんので、 紛失しないように大切に保管してください。
CALIFORNIA USA ONLY
Perchlorate Material–special handling may apply, See
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
CAN ICES-3 B / NMB-3 B.
Using the unit in the following locations can result in a malfunction.
• In direct sunlight.
• Locations of extreme temperature or humidity.
• Excessively dusty or dirty locations.
• Locations of excessive vibration.
• Close to magnetic fields.
Be sure to turn the power switch to OFF when the unit is not in use.
Remove the battery in order to prevent it from leaking when the unit is
not in use for extended periods.
Interference with other electrical devices
Radios and televisions placed nearby may experience reception
interference. Operate this unit at a suitable distance from radios and
To avoid breakage, do not apply excessive force to the switches or
If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use
liquid cleaners such as benzene or thinner, or cleaning compounds or
Keep this manual
After reading this manual, please keep it for later reference.
Keeping foreign matter out of your equipment
Never set any container with liquid in it near this equipment. If liquid gets
into the equipment, it could cause a breakdown, fire, or electrical shock.
Be careful not to let metal objects get into the equipment.
THE FCC REGULATION WARNING (for USA)
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If items such as cables are included with this equipment, you must
use those included items.
Unauthorized changes or modification to this system can void the
user's authority to operate this equipment.
Notice regarding disposal (EU only)
If this symbol is shown on the product, manual, battery, or
package, you must dispose of it in the correct manner to avoid
harm to human health or damage to the environment. Contact
your local administrative body for details on the correct dis-
posal method. If the battery contains heavy metals in excess
of the regulated amount, a chemical symbol is displayed
below the symbol on the battery or battery package.
IMPORTANT NOTICE TO CONSUMERS
This product has been manufactured according to strict specifica-
tions and voltage requirements that are applicable in the country
in which it is intended that this product should be used. If you have
purchased this product via the internet, through mail order, and/or
via a telephone sale, you must verify that this product is intended
to be used in the country in which you reside.
WARNING: Use of this product in any country other than that for
which it is intended could be dangerous and could invalidate the
manufacturer's or distributor's warranty.
Please also retain your receipt as proof of purchase otherwise your
product may be disqualified from the manufacturer's or distribu-
* All product names and company names are the trademarks or regis-
tered trademarks of their respective owners.
Thank you for purchasing the Korg SyncDancing SYNCHRO-
NIZED DANCE MUSIC PLAYER.
Features on this device
1. SYNC button (Hold down : Mute)
2. MODE button (Hold down :
4. Jog Switch
TIP Operate the jog switch by slid-
1 2 3
ing it in the direction of the
5. Ear clip
Attach the device to your ear as
shown in the diagram at right.
Attaching the device
To attach the device to your ear, open
the ear clip, place the round part near
the hollow part of your ear around the earhole, and
then close the ear clip.
the round part can rotate a maximum of 220degrees.
It will break if you attempt to rotate it fartherthan this.
A s th i s a s m a ll a n d light w e ight d e v i c e , th e re i s a r i s k
that small children may place it in their mouth and ingest it.
Keep the device out of reach and store it away from small children.
Inserting the battery
1. Slide the lid open.
2. Pull the lid
and then insert the
When inserting or replacing the battery, turn off the device's power.
Make sure to observe the correct polarity.
Turning on the power
1. To turn on the power, hold down the MODE button until the
2. To turn off the power, hold down the MODE button until the
display goes dark.
The entire display will blink if the battery has worn down. When this hap-
pens, replace the battery as soon as possible.
Using this device
Press the MODE button to switch between the setting screens for
), Volume (
), Delay (
), Tempo (
), Beat (
), and Tone (
), in that order.
Playing back a song
Set the song to play back using this device.
1. Press the MODE button to display the Song setting screen.
2. Select a song from
. Press the SYNC button to play back
the selected song.
Adjusting the song's playback timing
You can adjust the amount of time (delay) that will pass before playing
back the song after the device is attached .
1. Press the MODE button to display the Delay setting screen.
2. Set the delay time. The number indicates how many seconds will
pass before playback begins.
Setting the volume
1. Press the MODE button to display the Volume setting screen, and
use the jog switch to select the volume from
(Volume: Low) to
This device's volume has been set to be a little loud, since it may be used
when practicing musical instruments.If the device seems too loud, fasten it to
your ear at a position slightly away from the earhole.
To protect your hearing, avoid using this device for long periods of time
Setting the tempo
1. Press the MODE button to display the Tempo setting screen, and
use the jog switch to set the tempo from = 30 to 252 (BPM). Slide
and hold the jog switch to make the tempo continue to change.
Using this device as a metronome
When using this device as a metronome, set the beat and rhythm.
1. Press the MODE button to display the Beat or Rhythm setting
2. Press the SYNC button to switch the playback sound to a metronome.
3. Use the jog switch to set the beat and rhythm.
Beat: Select a beat from
(0 beat) to
Rhy thm: Select a rhythm pattern from
Changing the metronome sound
The metronome sound (tone) on this device can be changed.
1. Press the MODE button to display the Tone setting screen.
2. Select one of the tones from
These setting will be stored in the device. However, the settings will not be
stored if the device is not turned off in the ordinary manner (such as when the
battery run out).
The count timing for two or more SyncDancing devices can be synchro-
nized. The SyncDancing device that drives the base tempo is called the
"master", and the other SyncDancing devices that will follow that tempo
in sync are called "slaves".
This device uses infrared communication when syncing with other devices.
Do not use the sync functions around other devices that use infrared light, or
around plasma TVs.
1. Match the protruding part of
the SyncDancing that will be
the master to the recessed part
of the SyncDancing that will
be the slave, as shown in the
2. Press the SYNC button on
the SyncDancing that will be
TIP When synchronizing three or
more devices, connect the SyncDancing that will be the slave, as
shown in the diagram below., and press the SYNC button on the
master SyncDancing device.
Once the synchronization settings have been made, the slave SyncDancing's
settings will be replaced with those of the master. (Except the Volume and Delay
Synchronization will be canceled if the Tempo, Beat, or Song settings are
Muting the device
The song and metronome sounds can be muted.
1. Hold down the SYNC button. Press the SYNC button to cancel
Tempo: =30–252/min (BPM), Beat: 0–9 beat, Rhythm: Quarter Notes,
Duplets, Triplets, Quadruplets, Song: 20 songs, Tempo accuracy: ±0.1,
Speaker: dynamic speaker, Synchronization communications method:
infrared, Power supply: 3V lithium battery CR 2032, Battery life: approxi-
mately 5 hours (continuous use at Tempo = 120, Beat =
, Volume =
), Dimensions (WxDxH): 49 x 22 x 22 mm / 1.93" x
0.87" x 0.87", Weight: 10 g / 0.35 oz. (including battery), Included items:
Owner's Manual, CR2032 lithium battery (3V), ear pad, carrying case
* Specifications and appearance are subject to change without notice
, Rhythm =