HP D2700 User Manual page 33

2. Unlatch and swing out the latch handle on the drive. Then, slide the drive into the bay (1),
pressing firmly on the drive to seat it. Close the latch handle (2), pressing firmly until it locks in
place.
IMPORTANT:
When a drive is inserted in an operational enclosure, the drive LEDs flash to indicate that the
drive is seated properly and receiving power.
3. Determine the status of the hard drive (see
IMPORTANT:
For proper airflow and cooling, a drive blank must remain installed in all unused drive bays.
Drive status reporting).
D2600/D2700 Disk Enclosure User Guide 33