Electro-Voice RE-2 Operating Instructions Manual page 5

NOTE: Groups 9 and above are set up to work
with the other US frequency band (A and B). If
you are using a mix of Band A and Band B, scroll
down to these groups and use the clearest group.
6. Change Lock-Out: By pressing and holding the
UP and DOWN arrow keys together for 3 seconds,
the SET key is disabled. To reactivate the SET
key, simply press and hold the UP and DOWN
keys again for 3 seconds. This feature can be
useful when the receiver is in a location where
unauthorized personnel have access to the
receiver.
7. For set up, make sure the mixer or amplifier input
used for the RE-2 is muted or turned down to a
minimum level.
8. Plug an audio cable (not supplied) into the 3 pin
XLR or 1/4 inch output of the RE-2.
a. NOTE: The XLR connector is the preferred
connection since the output is balanced and will be
more immune to noise for longer runs of cable
although either can be used with good results. If
the 1/4 inch connector is used, adjust the output
level on the back panel to 12 o'clock (midway in
the range) to start and adjust later if necessary.
Receiver Push-Button Reference Sheet
Display Status Button
Nothing Flashing Press and hold SET
Nothing Flashing SET
Group flashing Press and hold SET
Group flashing SET
Channel Flashing Press and hold SET
Nothing flashing Press and hold UP
Nothing flashing Press and hold
UP & DOWN
Edit Lock On Press and hold
UP & DOWN
Power Off Press and hold SET
Nothing flashing Press SET und UP
Frequency Flashing Press and hold SET
ClearScan Band Press SET
Running
ClearScan Band
Results n/a
Frequency Mode Press SET und UP
Nothing flashing Press and hold DOWN
Now refer ahead to transmitter setup and return
to step 9 when that is completed.
9. With the transmitter on, speak into the microphone
or play the guitar. Turn up the level on the mixer
or amplifier until you are able to hear the desired
signal. If no audio is present, repeat setup and
refer to the troubleshooting section.
NOTE: If the 1/4 inch output is used, it may be
necessary to adjust the receiver output until the
volume level from the wireless system
approximates the level of an equivalent wired
microphone/instrument.
10. Squelch Adjustment - The squelch setting can
be used to maximize range or immunity to noise.
Press and hold Up for 3 seconds. The current
squelch setting will be displayed. Adjust the
squelch using the UP/DOWN keys. Maximum
squelch (9) maximizes noise immunity but
limits the range. Minimum squelch (1) will
maximize the range but allow more noise to
break through the squelch. Press SET to save
the new squelch setting.
Function Activated
Auto ClearScan
Edit Group – Group will Flash
ClearScan Group –
list clear groups in order
Edit Channel - Channel will Flash
ClearScan Channel – list clear
channels in order
Edit Squelch Setting
Edit Lock
– SECURE will appear
Return to access mode
Toggle between Guitar
and Voice mode
Toggle to frequency Mode
– Freq. will flash
ClearScan Band -
ClearScan will flash
End ClearScan Band after
next full Scan
Clearest frequencies listed
Return to Group and
Channel Mode
Display Software Revision
- -
3
English
Edit Accept
n/a n/a
SET
SET
SET
SET
SET
n/a n/a
n/a n/a
n/a n/a
SET
n/a SET
n/a n/a
SET
n/a n/a
n/a n/a