Connecting Speaker Cables - Panasonic RAMSA WS-AT300 Operating Instructions Manual

CONNECTING SPEAKER CABLES

You can find the TS (tip-sleeve) phone jack and
SPEAKON connector on the back of the enclosure.
These two are usable as input or output terminals since
they are wired in parallel. See the block diagram on
page 9.
1. Connect signal input from an amplifier to either TS
phone jack or SPEAKON connector.
2. Bridge the first speaker and the second when using
two speakers in parallel as illustrated.
Notes:
• Do not connect more than two speakers in parallel.
Excessively low impedance can cause distorted
output sound or damage to the amplifier.
• Match the sound phase of all speakers by
confirming the polarities of connection when using
two or more speakers.
From
amplifier
From
amplifier
From
amplifier
From
amplifier
-6-
TS phone jack
SPEAKON connector