Panasonic RAMSA WS-AT300 Operating Instructions Manual page 5

INSTALLING THE SPEAKER
• On wall or ceiling
You can install the speaker on a wall or ceiling with a
mounting bracket (not supplied).
q Place the bracket on the enclosure.
w Screw the eye bolts into the screw holes of the
enclosure by hand.
e Fix the speaker to a wall or ceiling.
r Take safety protections mentioned in "Secure the
speaker."
Note: Installers should seek advice on the building
structure and load capacity, if unknown, from
an architect or a structural engineer.
• Secure the Speaker
Use safety wires (not supplied) when hanging the
speaker from a wall or ceiling. This is not a major
means of support but just a safety relief.
q Tighten the eye bolts with washers and bolt nuts
(not supplied) into the screw holes of the enclosure
by hand.
w Set the direction of the eye bolts to be in the best
position for binding safety wires.
e Fasten the bolt nuts with wrench.
r Bind one end of safety wires to the eye bolts.
t Secure the other end of safety wires to the
supporting structure of the building.
• Mounting on a stand
1. You can mount the speaker on a speaker stand by
using the stand hole in the enclosure bottom.
2. The stand should have a supporting pipe of ø1.5
inches.
3. Take safety protections by placing it in a safety
location, for exemple.
Mounting
bracket
Set direction
Hand
tighten
Washer
Stand hole
(Bottom side)
-5-
Hand
tighten
Insert
Eye Bolt
Bolt nut
Tighten with wrench