Samsung ML-2851ND/XAZ Service Manual page 54

4.1.2.2 Network setup(ML-2851ND only)
This chapter gives you basic information for setting up your printer for network connections.
This chapter includes:
• Introduction
• Supported operating systems
• Using SetIP program
Introduction
Once you have connected your printer to a network with an RJ-45 Ethernet cable, you can share the printer with other
network users.
You need to set up the network protocols on the printer to use it as your network printer. Protocols can be set up by the
following programs:
• SyncThru TM Web Admin Service: A web-based printer management solution for network administrators. SyncThru
Web Admin Service provides you with an efficient way of managing network devices and lets you remotely monitor and
troubleshoot network printers from any site with corporate intranet access. You can download this program from
http://solution.samsungprinter.com.
• SyncThru TM Web Service: A web server embedded to your network print server, which allows you to configure the
network parameters necessary for the printer to connect to various network environments.
• SetIP: A utility program allowing you to select a network interface and manually configure the addresses for use with the
TCP/IP protocol.
This program is on the software CD that comes with your printer.
Supported operating systems
The following table shows the network environments supported by the printer:
Item
Network interface
Network operating system
Network protocols
Dynamic addressing server
• TCP/IP: Transmission Control Protocol/Internet Protocol
• DHCP: Dynamic Host Configuration Protocol
• BOOTP: Bootstrap Protocol
Service Manual
Alignment & Troubleshooting
Requirements
• 10/100 Base-TX
• Windows 2000/XP(32/64 bit)/2003/Vista
• Varios Linux OS including Red Hat 8 ~ 9, Fedora Core 1 ~ 4, Mandrake
9.2 ~ 10.1, SuSE 8.2 ~ 9.2
• Mac OS 8.6 ~ 9.2, 10.1 ~ 10.4
• TCP/IP
• EtherTalk
• HTTP 1.1
• SNMP
• DHCP, BOOTP
4-5
TM
Samsung Electronics