Panasonic CQ-DVR909U Operating Instructions Manual page 53

Parking Brake Cord
Caution:
≥ For safety's sake, and to prevent accidents,
the parking brake cord must be connected.
Hand-operated parking brake
Foot-operated parking brake
Chassis
Connecting the clamp connector @
≥ Attach the clamp connector to the vehicle cord at a
suitable position.
≥ Note that if the cord being clamped onto is too thin
(0.3 mm 2 or less), the connection may not be adequate.
1 Push the end of the side brake cord into the hole on the
clamp connector.
Place the vehicle cord into the groove in the clamp
connector.
2 While making sure that the cords do not slip out of the
clamp connector, press the element down with a pair of
pliers.
3 Close the cover until it snaps shut.
Note:
≥ The position of the parking brake switch
depends on the car. (The figure shows
examples of where the switch might be
located.) For details on the exact location of
the parking brake switch in your car, contact
your dealer.
Brake Lamp
Battery
@ Clamp Connector
Of the 2 cords emerging from the parking
brake switch, connect the player's parking
brake cord to the one that is not connected to
the vehicle's chassis while the brake is in the
released state.
Parking Brake Switch
Cords connected to
the vehicle
Parking Brake Cord
PARKING BRAKE
Blue/Yellow Stripe
Vehicle Cord
Push the end of the cord
in until it touches this part.
Parking Brake Cord
Element
Cover
CQ-DVR909U
E
N
G
L
I
S
H
46
65