7.5.
Removal of the J-Board
1. Remove the HU Terminal Block and the HA Terminal Block.
(Reference to Removal of the HU-Board and the HA-Board)
2. Remove the Slot Block.
(Reference to Removal of the Slot Block)
3. The slot block is turned inside out.
4. Remove the 6 screws and then remove the Slot cover.
5. Remove the 6 screws, release the coupler(J14) from HX-
Board and then remove the J-Board.
7.6.
Removal of the HX-Board
1. Remove the HU Terminal Block and the HA Terminal Block.
(Reference to Removal of the HU-Board and the HA-Board)
2. Remove the Slot Block.
(Reference to Removal of the Slot Block)
3. Remove the J-Board.
(Reference to Removal of the J-Board)
4. Remove the 2 screws and then remove the Slot Case.
5. Remove the 4 Hexagonal-Head screws and the 1 screw
and then remove the HX-Board.
7.7.
Removal of the DA-Board
1. Disconnect the couplers(DA1, DA3, DA5, DA6).
2. Remove the Flexible Cable from the coupler(DA2).
3. Remove the 4 screws and then remove the DA-Board.
Note:
A re-setup of the destination is performed by MS mode
after DA-Board exchange.
11
TH-42PS9UK