Installing The Center Speaker; Wall-Mounting The Speakers - Yamaha NS-P350 Owner's Manual

Installing the speakers

Installing the center speaker

TV rack, etc.

Wall-mounting the speakers

You can mount the speakers on the wall as follows.
40 mm
(1-5/8")
Wall/
wall support
3 mm
(1/8")
Minimum
20 mm (3/4")
1
Install screws into a solid wall or wall support as
shown in the illustration. Use 3.5 to 4 mm (1/8")
diameter self-tapping screws.
2
Hang each speaker by its keyhole slots onto the
protruding screws.
Note
Make sure the shaft of the screw is seated in the narrow
part of the keyhole slot. Otherwise, the speaker may
fall.
Warning
• Do not mount the speakers on thin plywood or on a wall with a soft surface material. Otherwise, the screws may pull
out of the surface and the speakers may fall, possibly damaging the speakers or causing personal injury.
• Do not install the speaker on a wall using nails, adhesives, or any other unstable hardware. Long term use and vibration
may cause it to fall.
• Be careful not to pinch the speaker cables between the speaker and the speaker bracket or speaker stand.
• To avoid accidents resulting from tripping over loose speaker cable, affix them securely to the wall.
• When using speaker brackets (commercially available) to mount the speakers on the wall or ceiling, we strongly
recommend using safety wire (may be supplied with the bracket) between the speaker and bracket to prevent the
speaker from falling.
• If you are not sure of a safe way to install these speakers, consult a professional installer or a building contractor.
2
En
Fastener
Peel off the seal.
NS-PB350
4.8 kg (10 lbs. 9 oz.)
Place the center speaker centrally between the front
speakers, facing directly forward.
When placing it on a flat surface (TV rack, etc), affix the
supplied fasteners to bottom of the speaker.
Refer to the illustration.
Note
Wipe the surface clean before affixing the fasteners. If the
surface is dirty, oily or wet, adhesive strength is weakened
and the speaker may fall.
Using a commercially-available speaker
stand
If you mount the speaker on a
commercially-available speaker
stand, use the mounting screw
holes on the bottom of the speaker.
Screw holes
Diameter:
4 mm (1/8")
Hole depth:
10 mm (3/8")
NS-PB350
Bottom
(Front)
45 mm
(1-3/4")
60 mm
(2-3/8")
(Rear)