Connecting To Your Amplifier - Yamaha NS-9900 Owner's Manual

Connections
Before making connection, make sure that the
amplifier is switched off.
• Connect the screw-type terminals at the rear of the
speakers to the speaker terminals on the amplifier with
a supplied speaker cable.
• Connect the + terminals on the amplifier and on the
speakers using one side of the cable. Connect the –
terminals on both components using the other side of
the cable.
• Connect one speaker to the left (L) terminals of your
amplifier, and another speaker to the right (R) terminals,
making sure not to reverse the polarity (+, –). If one
speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.
How to connect
1
Loosen the knob.
2
Twist the exposed wires of the cable together.
Good
10 mm
3
Insert the bare wire into the hole.
4
Tighten the knob and secure the cable.
Test the firmness of the connection by pulling the
cable lightly at the terminal.
When using a banana plug (China model only)
1
Unscrew the terminal knob.
2
Remove the cap by pulling it toward you.
Terminal
1
4
En

CONNECTING TO YOUR AMPLIFIER

No Good
2
Notes
• Do not let the bare speaker wires touch each other as
this could damage the speaker and/or the amplifier.
• Do not insert the insulation coating into the hole.
The sound may not be produced.
Speaker
terminals of
the amplifier
+
NS-9900 (R)
Black (–)
Terminal hole
Insulation coating
3
Tighten the terminal knob.
4
Simply insert the banana plug into the terminal.
Banana plug
Amplifier
SPEAKERS
R
L
A
– – +
B
NS-9900 (L)
Loosen
Tighten
Red (+)
Bare wire
3
4