Connecting The Speaker - Yamaha NS-C225 Owner's Manual

Connecting the Speaker

Always turn off your amplifier or receiver before making any connections.
■ Preparing Your Speaker Cables
Carefully remove 10 mm (3/8")of insulation from
both ends of your speaker cables and twist the
bare wires tightly, as shown.
10 mm
(3/8")
Good No Good
■ Hookup
Tighten
Loosen
–
NS-C225
Amplifier or
receiver
Notes:
• Make sure that the bare wires are not touching
each other as this could damage the speaker and
amplifier.
• Connect one speaker to the left terminals of your
amplifier, and another speaker to the right
terminals, making sure not to reverse the polarity
(+, –). If one speaker is connected with reversed
polarity, the sound will be unnatural and lack bass.
+
CENTER REAR
R L
(SURROUND)
+
–
■ Using a Banana Plug
1.
Remove the speaker terminal cover by
gently pulling it toward you.
2.
Tighten the terminal knob.
3.
Simply insert the banana plug into the
terminal.
3
1
Banana Plug
2
3
E-