Table of Contents
Advertisement
Controls & Connectors
Subwoofer rear panel
USB
1
INPUT
TO RIGHT
1
SPEAKER
INPUT
2
1 USB INPUT
Use the included USB cable to connect this port to the USB port on the computer.
2 TO RIGHT SPEAKER
Connect the 8-pin cable from the right satellite speaker to this connector.
3 INPUT 1/2
You can input two audio sources to the speaker system from these input jacks. For example, you can connect the
output of a CD-ROM player and a personal computer here. The two audio sources are mixed together by the
speaker system.
4 TO LEFT SPEAKER
Connect the RCA plug cable from the left satellite speaker to this connector.
5 BASS control
Allows you to adjust the volume level of the subwoofer.
A typical (recommended) setting is the position between one o'clock and two o'clock.
Rotating the control clockwise will increase the volume level, and rotating the control counter-clockwise will
decrease the level.
6 DC connector
Connect the included AC adapter to this connector. Press the
to turn the power on or standby.
7 VOLUME control
Allows you to adjust the volume level of the entire speaker system.
Rotating the control clockwise will increase the volume level, and rotating the control counter-clockwise will
decrease the level.
8
(standby/on) button/indicator
Press this button to turn on the power to the speaker system. Its indicator lights up. Press the button again to turn
the speaker system to standby mode.
Before pressing this button, make sure that the VOLUME control setting is lowered. A small electrical current
flows through the speaker system even if the standby/on button is turned off.
3
2
TO LEFT
INPUT
SPEAKER
4
3
0
10
DC 15V
BASS
5
6
(standby/on) button on the right satellite speaker
Right satellite speaker top side
VOLUME
7
8
Advertisement
Table of Contents
