Advertisement
Quick Links
Download this manual
See also:
User Manual
dimension & installation guide
built-under dishwasher – DX303
IMPORTANT
• These instructions are a guide only. For complete
installation instructions, refer to the manual provided with
the product.
• If you do not follow the installation instructions your
dishwasher will not be properly installed. The product
warranty does not cover incomplete or improper
installation. You will be charged a service fee for any service
call to rectify improper or incomplete installation.
• These instructions apply to built-under applications only.
Dishwasher Dimensions
The dimensions shown below are in millimetres.
The height of 820mm is with the levelling legs
screwed in all the way.
100mm
595mm
120mm
Typical builT-unDer insTallaTion
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
Secure dishwasher with
brackets and screws provided
DISHWASHER
Gap on both sides
should be equal and no greater
than 3mm maximum per side
Kickplate fixing screws
If floor is not level, adjust
levelling legs to suit
cupboarD opening Dimensions
The dimensions shown below are in millimetres. The opening
allows for some clearance so that the dishwasher can be
pushed into place.
Note: if the opening is greater than 600mm wide then a suitable
width filler piece should be secured to the cupboard before
installing the dishwasher.
820mm
180mm
50mm
555mm edge of door
585mm centre of door
The hose should not be
extended by more than
2 metres or water pump-out
problems may occur
600mm max -
300mm min
POWER OUTLET
Fix drain hose max of
10mm below the top of
the dishwasher
SINK
1000mm max
POWER SUPPLY
230/240V–10Amps
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to
spigot with clamp
TAP CONNECTION
If cold-water pressure is
in excess of 800kPa, a
pressure-reducing valve
should be used.
Check for leaks.
INLET WATER SUPPLY
Water flow rate 10L/minute min
Water temperature 60°C max
Water pressure cold water:
800kPa max - 50kPa min
Water pressure hot water:
350kPa max - 50kPa min
Cold water recommended
(Refer page 3 for further information)
page 1
Advertisement
Related Manuals for Electrolux DX303
Summary of Contents for Electrolux DX303
-
Page 1: Dishwasher Dimensions
& installation guide built-under dishwasher – DX303 cupboarD opening Dimensions IMPORTANT The dimensions shown below are in millimetres. The opening allows for some clearance so that the dishwasher can be • These instructions are a guide only. For complete pushed into place. - Page 2 & installation guide built-under dishwasher – DX303 levelling CAUTION Good levelling is essential for correct closure and sealing of the door. Carefully follow the instructions on the template When the appliance is correctly levelled, the door will not enclosed with the product for building the catch or rub on either side of the cabinet.
-
Page 3: Connection To Water Supply
& installation guide built-under dishwasher – DX303 connecTion To waTer supply IMPORTANT The inlet hose should be inspected every 12 months for deterioration and replaced if necessary. • Ensure that hoses are not crushed or kinked under or behind the dishwasher. -
Page 4: Connecting The Drain Hose
& hold or quick 30 cycle and that the dishwasher fills with water, washes and drains with no leaks. The manufacturer accepts no liability for failure to observe the above safety precautions. © Copyright 2007 Electrolux Home Products Pty Ltd ABN 51 004 762 341 page 4 DISH303INSTALL_Jul07...