User File Setting - Panasonic GP-KS1000E Operating Instructions Manual

USER FILE SETTING

User preference stored can be accessed by selecting
user switch.
1. Remove the switch cover on the rear of the camera
control unit by removing the screw.
@0 @5 @7 @9 #1
ON
1
@1 @2
2. Select a desired user file (1 - 4) by turning User
Switch !0 on the front panel.
3. Set User File Set On/Off Switch @5 on the rear panel
to ON.
4. Select an item for adjustment by turning User File
Item Switch @2 on the rear panel.
The item numbers and the corresponding items are
shown below.
Adjust control @3 Select switch @4
Item No. Item
0 G/L H Phase
G/L SC
1
Coarse/Phase
2 DTL Level
3 Chroma Gain
Colour Matrix
4
(R-G)
Colour Matrix
5
(B-G)
6 Pedestal Level
AGC/ELC
7
Sensing Zone
8 (NC)
Reset All
9
Settings
Screw
@6 @8 #0 #2
2 3 4 5 6 7 8
@3 @4
Valid Invalid
Valid 0:0°
1:90°
Valid
2:180°
3:270°
Valid Invalid
Valid Invalid
Valid Invalid
Valid Invalid
Valid Invalid
0: ALL
1: CENTRE
Invalid 2: S CIRCLE
3: M CIRCLE
4: L CIRCLE
Invalid Invalid
AGC/ELC Sensing Zone (Item No. 7)
0:ALL
3:M CIRCLE
Note: Item 1 and 2 settings are not stored at each user
file distinctively.
5. Select or adjust the level of each item by the User
File Select switch @4 or User File Adjust control @3 .
6. Press User File Set switch @1 to store the adjusted
value in the memory.
7. Repeat the above steps 4 to 6 set the other items.
8. After all the necessary items have been set, set Use
File Set ON/OFF Switch @5 to OFF.
9. Place the switch cover back on the switch panel on
the rear of the camera control unit and fasten it with
the screws.
Caution
Do not set User File Item switch @2 to A through F
positions.
If A to F is selected, use both User File Item switch @2
and User File Select switch @4 to the position F, then
press User File Set switch @1 .
-10-
1:CENTRE 2:S CIRCLE
4:L CIRCLE