Bissell SPOTCLEAN CORDLESS 1570 series User Manual page 6

Operations
e. Replace the tank by lining up tank
bottom with indentations on machine.
Press down firmly on tank to secure in
position.
2. Release the flex hose from the hose grip bracket.
Unwrap flex hose completely from around the unit.
3. Select desired tool for spot cleaning. Insert
tool on end of hose until it clicks into place.
Pre-treating
Cleaning effectiveness will be enhanced if you
pre-treat heavily stained or highly soiled areas.
Here's how to do it:
1. Hold the 3" Tough Stain Tool just above the
carpet or upholstery to be cleaned. Press the
trigger to mist solution over the soiled area. For
the 3-n-1 Stair Tool, follow instructions on page 7.
2. Wait 3-5 minutes before cleaning.
Cleaning with the Tough Stain Tool
1. Attach the 3" Tough Stain Tool to the handheld
cleaning hose. (You will hear a click when it is
properly attached.)
2. Press the power button beneath the handle
to turn it on. (Make sure unit is fully charged by
checking the battery status indicator lights)
3. Hold the tool 1 inch above soiled surface.
4. Press the spray trigger to mist solution over
and onto the soiled area.
5. Release the spray trigger and gently scrub
the stain.
6. To lift the stain away, apply downward
pressure on the tool and slowly pull it toward
you. Watch as powerful suction removes the
dirt and cleaning solution. Continue until no
more dirt can be removed.
7. As a final step, use "drying strokes" (by not
pressing the spray trigger) to remove as much
moisture as possible. Repeat this step as often
as necessary.
NOTE: Oxy Boost formula will continue to clean
oxidizable stains for 6-8 hours.
Tips
www.BISSELL.com
6
» Deep cleaning stairs and high-traffic areas on a regular
basis helps prolong carpet life.
» Check upholstery stuffing before cleaning. Colored
stuffing may bleed through the fabric when it
becomes wet.
WARNING
Keep spray away from face. Failure to do
so may result in personal injury.
1e.
IMPORTANT
Check the manufacturer's tag before
cleaning upholstery. "W" or "WS" on the tag
means you can use your SpotClean. If tag
is coded with an "S" (with diagonal strike-
through), or says "Dry Clean Only," do not
proceed. If manufacturer's tag is missing or
not coded, check with your furniture dealer.
» Before turning off the machine, suction up clean
water to thoroughly rinse out the interior of the flex
hose. Then, lift the cleaning tool and point it upwards
to drain any remaining water into the dirty water/
collection tank.
3.