Mistral MM-6 Instruction Manual page 10

Connections
Analogue Input
Speaker
Output
Subwoofer
Output
Pre Amplifier
Output
Pre Amplifier
Output and
How to connect conventional
components (i.e. Tuner, Tape
Deck, SACD player)
Connect an RCA cable to the
RCA inputs on the back of the
MM-6. Take care not to connect
them to the RCA pre amp
outputs.
To use a turntable an external
phono pre-amp will be required.
Consult your dealer for
recommendations.
The MM-6 is designed to drive
one pair of speakers between 4-
8 ohms. However it can be
used with more than one pair if
appropriately matched. Consult
your Authorised Dealer to advise
on this.
The RCA Pre Amp Outputs can
be used for several applications.
To use as a subwoofer output,
run a stereo pair of RCA cables
from the pre amp output to the
subwoofer RCA line input. If
your subwoofer has only one
line input, you can use a Y
Adapter (Dual Male to Single
Female) to connect the
subwoofer to your MM-6
amplifier. This will give you a
single output.
Connect a Stereo RCA cable
from the pre amp output of the
MM-6 to the stereo inputs on
your external amplifier.
You will need to split the L/R
outputs to two L/R outputs. To
10