Table of Contents
Advertisement
Installation Manual
Quidway S6502 Ethernet Switch
Figure 4-13 Cable binding example II
Before bending the cables, bind them first. Mind that no tie binds the bended part
of any cables, for fear of cable core breaking due to excessive stress. See the
following figure.
Figure 4-14 Cable binding example III
The spare cables or excessive parts should be folded and bound and located at
right places in a cabinet or on the cable channel. In the so-called right places, the
running device will not be affected or damaged and the cables will not be damaged,
either.
220V power cord and -48V power cord cannot be tied on the guides of any mobile
components;
Keep excessive parts of power cords for those mobile components, such as
ground wire of doors, to free the cables from possible stress. When installing these
components, make sure the excessive cables will not touch heat source, sharp
point, or keen edges. Use high temperature cables near the heat sources;
Huawei Technologies Proprietary
4-13
Chapter 4 Hardware Installation
Advertisement
Table of Contents
Troubleshooting
