Starting The Memory; Changing The Basic Settings; Basic Settings; Care And Cleaning - Siemens HF35M562 Instruction Manual

Press the button for the microwave power setting you require.
2.
The display above the power lights up and a suggested
cooking time is displayed.
Set the cooking time using the rotary selector.
3.
Press and hold the or
j
4.
signal sounds.
The setting is saved and can be started at any time.
Saving another setting
Enter and save the new setting. The old settings are
overwritten.
Note: The programmes which have been set remain stored
even if there is a power cut.

Starting the memory

You can start cooking at any time using the settings saved for
your meal.
Press the button.
Ž
1.
Your appliance is ready for use.

Changing the basic settings

Your appliance has various basic settings which you can
change at any time.

Basic settings

In the table, you will find all the basic settings and options for
changing them.
Basic setting
Clock display
™‚
= on
‚
Signal duration
™ƒ
= medium = 2 minutes
ƒ
Button tone
™„
‚ = on
Waiting time
™...
= medium = 5 seconds
ƒ
Prerequisite: your appliance is switched off.
Press and hold the button for a few seconds.
0
1.
The first basic setting appears in the display.
You can change the basic setting by turning the rotary
2.
selector.

Care and cleaning

With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
:
Risk of short circuit!
Never use high-pressure cleaners or steam cleaners to clean
the oven.
:
Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
8
button for a few seconds until a
k
Options
Clock display
= off
ƒ
= short = 10 seconds
‚
„ = long = 5 minutes
Button tone
ƒ = off
= short = 2 seconds
‚
= long = 10 seconds
„
j or ( button. k
2.
The stored settings are displayed.
Press the start button.
3.
The memory setting starts. The
in the display.
Note: Once operation has started, you can no longer change
the memory location.
The cooking time has elapsed.
A signal sounds. The memory function has finished. Use
the Ž button to switch off the appliance or make new
settings. You can stop the audible signal by pressing the
button.
Pausing
Press the STOP button or open the appliance door. Operation
is suspended. After closing, press the start button. Operation
will then continue.
Explanation
Displays the clock
Audible signal after the cooking time has
elapsed
Confirmation tone when a button is pressed
Waiting time between two separate steps,
after setting
Confirm by pressing the
3.
The next basic setting appears in the display. You can go
through all of the basic settings with the
changes with the rotary selector.
To finish, press and hold the
4.
All settings are applied.
You can change the settings at any time.
Notes
Slight differences in colour on the front of the appliance are
■
caused by the use of different materials, such as glass,
plastic and metal.
Shadows on the door panel which look like streaks, are
■
caused by reflections made by the oven light.
Enamel is baked on at very high temperatures. This can
■
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
cooking time counts down
x
0 button.
button and make
0
button for a few seconds.
0
0