Electrolux EWF 10470 W User Manual page 37

132979220.qxd
6. Open the porthole, take out the inlet
7. Fill the smaller upper hole and the two
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets,
rugs etc. Check that the machine does
not touch the wall or other kitchen units.
Level the washing machine by raising or
lowering the feet. The feet may be tight
to adjust as they incorporate a self
locking nut, but the machine MUST be
level and stable.
If necessary, check the setting with a
spirit level.
Any necessary adjustment can be made
with a spanner.
Downloaded From WashingMachine-Manual.com Manuals
30/08/2006 12:04
hose from the drum and remove the
polystyrene block fitted with the
adhesive tape on the door seal.
HEC0010
large ones with the corresponding
plastic plug caps supplied in the bag
containing the instruction booklet.
HEC0005
Pagina 37
Accurate levelling prevents vibration,
noise and displacement of the machine
during operation.Never place cardboard,
wood or similar materials under the
machine to compensate for any
unevenness in the floor.
HEC007S
Water inlet
An inlet hose is supplied and can been
found inside the machine drum. Do not
use the hose from your previous
machine to connect to the water supply.
1. Open the porthole and extract the
inlet hose.
2. Connect the hose with the angled
connection to the machine.
Do not place the inlet hose
downwards. Angle the hose to the
left or right depending on the
position of your water tap.
HEC0006
3. Set the hose correctly by loosening
the ring nut.
installation electrolux 37