Related Manuals for Roundup DFW-150
Summary of Contents for Roundup DFW-150
- Page 1 Manufacturing nuMbers: 9100109 9100805 9100120 9100160 9100164 9100190 Deluxe FooD Warmer Models DFW-150/250 P/N 1010966 Rev. C 07/09 DFW-150 Shown owner s manual ’...
-
Page 2: Table Of Contents
• Normal maintenance as outlined in this manual. Your Deluxe Food Warmer (steamer) is manufactured from the finest materials available and is assembled to • Malfunction resulting from improper maintenance. Roundup’s strict quality standards. This unit has been • Damage caused by abuse or careless handling. tested at the factory to ensure dependable trouble-free • Damage from moisture into electrical components. -
Page 3: Service/Technical Assistance
Deluxe FooD WarMer Owner infOrMatiOn service/technical assistance Use only genuine Roundup replacement parts in this unit. Use of replacement parts other than those sup- If you experience any problems with the installation or plied by the manufacturer will void the warranty. Your... -
Page 4: Important Safety Information
Deluxe FooD WarMer iMpOrtant safety infOrMatiOn In addition to the warnings and cautions in this manual, • All electrical connections must be in accor- use the following guidelines for safe operation of the dance with local electrical codes and any unit. other applicable codes. • Read all instructions before using equipment. • warning electrical sHOcK HazarD. - Page 5 Deluxe FooD WarMer iMpOrtant safety infOrMatiOn (continued) the following tips are recommended for main- cautiOn tenance of your stainless steel equipment. all electrical connections must be in accordance with local electrical codes and any other appli- - always use a soft, damp cloth for cleaning, cable codes.
-
Page 6: Specifications
& plug configurations Model & Model & voltage watts amps Hertz Description configuration Mfg. no. Mfg. no. DFW-150 DFW-150 NEMA 5-15P, 9100109 9100109 15 Amp., 120 VAC., 9100805 1800 50/60 9100805 WHT BLK Non – Locking 9100160 9100160 (Assembly Only). -
Page 7: Installation
OTHER VOLTAGE SUPPLY COMPLETELY VOIDS ALL figure 1. components VAC ONLY WARRANTY. PLEASE CHECK nOte: Dfw-150 models are designed to use cold YOUR LINE VOLTAGE BEFORE INSERTING THIS PLUG INTO THE tap water. Distilled water may be used to reduce RECEPTACLE. - Page 8 Deluxe FooD WarMer installatiOn Direct water HOOK-up (Dfw-250 Only) 3. Turn the water valve on. DFW-250 models require a direct cold water hook-up. 4. Hold the Quick Disconnect Insert over a bucket, A Water Inlet Hose and Strainer Assembly (Figure 3) then press and hold the white plastic tip until are supplied.
-
Page 9: Operation
Deluxe FooD WarMer OperatiOn programming cyc (total cycle time) refers to the total amount of steaming time set for the product. ready light sHO (shot interval time) is the time set between READY shots of steam during a complete cycle. Message H2O setting (steam shot time) is used to adjust the Display... - Page 10 Deluxe FooD WarMer OperatiOn (continued) 7. Press and release the prOgraM button again 10. Press either the start/stOp or cycle button and use the ▲ or ▼ buttons to change the SHO to store the changes and to exit the PROGRAM setting in minutes (Figure 5, Item F). mode. nOte: 00 minutes is recommended. nOte: the start/stOp or cycle button may be pressed at any time during programming to store 8.
-
Page 11: Hi-Limit Reset Button
Deluxe FooD WarMer OperatiOn (continued) fault codes Hi-limit reset button When the programming parameters for Minutes/ A hi-limit thermostat will turn off electrical power to the Seconds/SHO/H2O have been inadvertently changed heater if the unit overheats. To reset this thermostat, to a setting below or above their limits, the unit displays allow sufficient time (about 45 minutes) for the unit to the “ERR”... -
Page 12: Maintenance
This will eventu- safety information section of this manual. ally severely reduce the steaming action. water tanK filter (Dfw-150 Only) cautiOn Do nOt use a sanitizing solution or abrasive The Water Tank Filter is used to prevent particles or materials. - Page 13 Deluxe FooD WarMer Maintenance (continued) cleaning tHe spray tube anD nOte: if deposits are still excessive and/or difficult steaM generatOr to remove, refer to steps 6 through 11 below. 1. Turn the unit off and unplug the power cord. 6. Pour delimer solution (not supplied) onto the Allow the unit to cool down before proceeding.
- Page 14 Deluxe FooD WarMer Maintenance (continued) spare O-rings (3) tubing O-ring O-ring nOte: if the Male Quick Disconnect fitting leaks water while Male Quick Mesh Disconnect it is engaged into the rear of the steamer, then the O-ring strainer strainer cup insert must be replaced.
-
Page 15: Troubleshooting
Deluxe FooD WarMer trOublesHOOting warning To avoid possible personal injury and/or damage to the unit, inspections, tests, and repairs of electrical equipment should be performed by qualified service personnel. the unit should be unplugged when ser- vicing, except when electrical tests are required. if the troubleshooting steps listed do not solve your machine problem, contact the nearest authorized service agency for further assistance or service. - Page 16 Deluxe FooD WarMer trOublesHOOting (continued) problem possible cause corrective action “ERR” appears on the Programming and or sHO and H2O values Reset the Control Board as described in Control Display. were adjusted/changed improperly. the Programming section of this manual. See Fault Codes. Unit heats but there is Filter Strainer and/or Spray Tube is restricted.
- Page 17 Deluxe FooD WarMer trOublesHOOting (continued) problem possible cause corrective action Excessive Programming and or sHO and H2O Reprogram the SHO and H2O values as described condensation in values were adjusted improperly. in the Programming section of this manual. food compartment. Steam Generator’s Insufficient preheat time.
-
Page 18: Replacement Parts
Deluxe FooD WarMer replaceMent parts item part Description Qty. Dual water pressure regulator Kit - part no. 7000235 to steamer 2080105 Elbow, Quick Disconnect - 1/4” to steamer 2030126 Tubing 1/4” I.D. PVC BRD. 24” Long 1 2030125 Tubing 1/4” I.D. PVC BRD. 12” Long 1 2040150 Elbow, Male - Nylon 1/4”... - Page 19 Deluxe FooD WarMer replaceMent parts (continued) 9 (See page 6) P/N 1010966 Rev. C 07/09...
- Page 20 Deluxe FooD WarMer replaceMent parts (continued) Inset A See Inset B (Mfg. # 9100120 only) See Inset A Inset B – Self-Contained Water Tank Inset B – Direct Water Hook-Up P/N 1010966 Rev. C 07/09...
- Page 21 Deluxe FooD WarMer replaceMent parts (continued) item part Description Qty. item part Description Qty. 0012096 Top Cover Assy. (Incl. Nos. 2, 3 & 4) 45 7000142 Outlet Tube Kit 0021534 Top Cover (Incl. Nos. 46, 47 & 48) 0504653 Liner, Top Cover 46 204P114* Elbow, Female, 1/4”...
-
Page 22: Wiring Diagram
Deluxe FooD WarMer wiring DiagraM P/N 1010966 Rev. C 07/09... -
Page 23: Notes
Deluxe FooD WarMer nOtes P/N 1010966 Rev. C 07/09... -
Page 24: Limited Warranty
2. Roundup reserves the right to make changes in design or add any improvements on any product. The right is always reserved to modify equip- ment because of factors beyond our control and government regulations.