Precautions With Regard To Safety; Warning - Panasonic PT-AE4000U Operating Instructions Manual

Precautions with regard to safety

WARNING

POWER
„
The wall outlet or the circuit breaker shall
be installed near the equipment and shall
be easily accessible when problems occur.
If the following problems occur, cut off the
power supply immediately.
Continued use of the projector in these conditions will
result in fire or electric shock.
If foreign objects or water get inside the projector,
z
cut off the power supply.
If the projector is dropped or the cabinet is broken,
z
cut off the power supply.
If you notice smoke, strange smells or noise coming
z
from the projector, cut off the power supply.
Please contact an Authorized Service Center for repairs,
and do not attempt to repair the projector yourself.
During a thunderstorm, do not touch the
projector or the cable.
Electric shocks can result.
Do not do anything that might damage the
power cord or the power plug.
If the power cord is used while damaged, electric
shocks, short-circuits or fire will result.
Do not damage the power cord, make any
z
modifications to it, place it near any hot objects,
bend it excessively, twist it, pull it, place heavy
objects on top of it or wrap it into a bundle.
Ask an Authorized Service Center to carry out any repairs
to the power cord that might be necessary.
Insert the power plug securely into the wall
outlet.
If the plug is not inserted correctly, electric shocks or
overheating will result.
Do not use anything other than the provided power
z
cord and ground in the wall outlet.
Do not use plugs which are damaged or wall outlets
z
which are coming loose from the wall.
Clean the power plug regularly to prevent it
from becoming covered in dust.
Failure to observe this will cause a fire.
If dust builds up on the power plug, the resulting
z
humidity can damage the insulation.
If not using the projector for an extended period of
z
time, pull the power plug out from the wall outlet.
Pull the power plug out from the wall outlet and wipe it
with a dry cloth regularly.
Do not handle the power plug with wet hands.
Failure to observe this will result in electric shocks.
Do not overload the wall outlet.
If the power supply is overloaded (ex., by using too
many adapters), overheating may occur and fire will
result.
E
6 - NGLISH
ON USE/INSTALLATION
„
Do not place liquid containers on top of the
projector.
If water spills onto the projector or gets inside it, fire or
electric shocks will result.
If any water gets inside the projector, contact an
Authorized Service Center.
Do not place the projector on soft materials
such as carpets or sponge mats.
Doing so will cause the projector to overheat, which can
cause burns, fire or damage to the projector.
Do not set up the projector in humid or dusty
places or in places where the projector may
come into contact with oily smoke or steam,
ex., a bathroom.
Using the projector under such conditions will result
in fire, electric shocks or components deterioration.
Components deterioration (such as ceiling mount
brackets) may cause the projector which is mounted on
the ceiling to fall down.
Do not install this projector in a place which
is not strong enough to take the full weight
of the projector or on top of a surface which
is sloped or unstable.
Failure to observe this will cause projector to fall down
or tip over the projector, and severe injury or damage
could result.
Do not place another projector or other
heavy objects on top of the projector.
Failure to observe this will cause the projector to
become unbalanced and fall, which could result in
damage or injury. The projector will be damaged or
deformed.
Installation work (such as ceiling suspension)
should only be carried out by a qualified
technician.
If installation is not carried out and secured correctly it
can cause injury or accidents, such as electric shocks.
Do not use anything other than an authorized
z
ceiling mount bracket.
Be sure to use the provided accessory wire as an
z
extra safety measure to prevent the projector from
falling down. (Install in a different location to the
ceiling mount bracket)
Do not cover the air inlet port or the air
outlet port.
Doing so will cause the projector to overheat, which can
cause fire or damage to the projector.
Do not place the projector in narrow, badly
z
ventilated places such as closets or bookshelves.
Do not place the projector on cloth or papers, as
z
these materials could be drawn into the air inlet
port.