Setting Up Five Presets; Programming The Remote Jack For The Bypass Function; Specifications - Art SGX LT Manual

on the right. Set this number for the last entry number desired. In this example
we'll set the number to [04.] for the sequence of FIVE presets desired. If you
set the number to [00.], you will have programmed the jack for use as a bypass
jack. Now press the MIDI button and increment down to the desired MIDI Program
Number.
Note, when you pass [9.9] a letter and a number appear. [A.0] is equal to 100,
[b.0] is equal to 110, [C.0] is equal to 120. [C.7] is the last "number" and is
equal to 127. Press the BYPASS button and set the display for the desired PRESET
number.
Program the sequence to be 64, A1, 55, Y4 and H1. If you have gone through
Example 1, the first four presets have been set all ready. All you need to do is
add the fifth preset.
After programming is completed press and hold the MIDI button then the BYPASS
button to exit. Now, each time the footswitch is activated, you will change
presets in the selected sequence. The sequence of presets will wrap-around to the
beginning, at the end of the sequence.
EXAMPLE 5
Setting up five presets for Increment Preset Mode. Use preset numbers 64, A1, 55,
44 and H1.
*-Enter the MPT edit mode
*-With the left decimal point blinking, increment up (use RAPID ACCESS mode)
until the display reads [l.P].
*-Press the BYPASS button
*-Adjust the display to read [04.].
*-Press the MIDI button
*-Increment down (use HYPERSPEED) until the display reads [0.0].
*-Press the BYPASS button and set the display to read [64.].
*-Press the MIDI button and set the display for [0.1].
*-Press the BYPASS button and set the display to read [A1.].
*-Continue this until you reach and program [0.4] to be [H1.].
*-Exit MPT edit mode
You have just programed the SGX LT to sequence through five PRESETS when the
REMOTE jack is activated.
EXAMPLE 6

Programming the REMOTE jack for the BYPASS function.

*-Enter MPT edit mode.
*-Increment up until the display reads [l.P].
*-Press the BYPASS button.
*-Set the display to read [00.].
*-Exit MPT edit mode.
The FOOTSWITCH jack can now be used as an external BYPASS jack.
ART SGX LT SPECIFICATIONS
Presets..................................................... 250
Dynamic Range .....................................>85dB Typical
Equivalent Input Noise...................................-107dBv
16