2.4 GHz and 5 GHz Outdoor 3-Port MIMO Omnidirectional Antennas (J9719A and J9720A) Guide
The HP J9719A and J9720A and all associated equipment should be
installed in accordance with applicable local and national electrical code
guidelines to ensure safe operation.
Before connecting an outdoor antenna to an HP Wireless Access
Point, be sure that the access point radio power levels are set in
accordance with local regulatory requirements. For information
on setting radio power levels, see Transmit power control in the
MSM3xx/4xx Access Points Management and Configuration Guide.
For mandatory antenna power settings by country/region,
look for Antenna Power-Level Setting Guide (for MSM products)
at www.hp.com/support/manuals (search by antenna part number).
Please read all instructions carefully before attempting to install
and use this product.
Grounding: System grounding and lightning protection are essential,
especially for exterior-mounted antennas exposed to the elements.
Never install an antenna where it may fall and contact electrical lines.
wArrAnTY And SupporT inFormATion
See the warranty and support information included with this product. For
the latest information go to www.hp.com/networking/support.
© Copyright 2011, Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice.
Printed in Malaysia,
October 2011
Part Number: 5998-2272
SAFETY
Image of J9719A and J9720A
dESCripTion
The HP J9719A and J9720A are single-band omnidirectional antennas
for use in 802.11n MIMO applications. Enclosed in a weatherproof,
rugged radome, these antennas include a mast mount for outdoor
deployment. Each of the three MIMO antenna elements are connected
to the access point via low loss, outdoor rated coaxial pigtails. The
radiation patterns are uniform and symmetrical, providing excellent
signal level into defined coverage areas.
These antennas will enhance the performance of 802.11n systems.
SpECiFiCATionS
Item
Frequency
2400 MHz - 2500 MHz
Gain
Polarization
3dB Beamwidth
VSWR
Impedance
Power
Port-to-port Isolation
Downtilt
Cable Length
RF Connector
Cable Type
Radome Material
Size
Weight
1.51 kg (3.32 lbs)
Mounting
Wind Surface Area
(Curvature)
Wind Survival
Wind Gust Survival
Operational Temperature
Storage Temperature
Ingression Protection
J9719A
J9720A
5150 MHz - 5875 MHz
6 dBi
8 dBi
Linear, Vertical
26°
15.5°
2:1, Max
50 Ω
5W x 3
22 dB
0°
91 cm (36") x 3
Type N, Male (x 3)
RG58, Low Temp. Plenum rated
Polycarbonate, White
248 mm height x 210 mm diameter,
(9.76" x 8.27"), not including brackets
1.53 kg (3.37 lbs)
Mast Mount 31.8 mm - 57.2 mm diam.
(1.25" - 2.25" diam.)
0.03 m
(0.328 sq. ft)
2
200 km/h (125 mph)
266 km/h (165 mph)
-40°C to +70°C
(Cable Install Low Temp -20°C)
-40°C to +85°C
IP67