Monitor Information Window - Panasonic PT-LW80NT Network Operation Manual

Using WebBrowser

Monitor information window

This page indicates the projector status.
If you migrate from other pages, click [Monitor information] in the main menu (left of the screen).
Monitored information
On this window, click the [Status information] tab.
The monitor information is refreshed at fixed intervals, but the current exact information can be checked by clicking [View] →
[Refresh].
If [SELF TEST Error (Detail)] appears on the monitored
information window, click it to view the error details.
n If [FAILED] appears
Item
MAIN CPU BUS
FAN
INPUT AIR TEMPERATURE
OUTPUT AIR TEMPERATURE
LAMP REMAIN TIME
LAMP STATUS
INPUT AIR TEMP.SENSOR
OUTPUT AIR TEMP.SENSOR
BATTERY
ACF UNIT
FILTER REMAIN
(cont.)
Description
There is a problem with a microcontroller circuit. Contact your dealer.
There is a problem with the fan or fan drive circuit. Contact your dealer.
Input air temperature is high. The projector is likely being used in a high temperature
environment such as near heating equipment.
Temperature surrounding the lamp is high. The exhaust vent is likely blocked.
The lamp has been used for longer than its rated useful life, and it is time to replace it.
The lamp could not be lit.
Allow the bulb of the light source to cool, and then turn on the projector.
There is a problem with the air intake temperature sensor. Contact your dealer.
There is a problem with the exhaust temperature sensor. Contact your dealer.
The battery must be replaced. Contact your dealer.
Either the ACF unit is not set properly or it does not work. For further detail, see the
instruction manual for the projector.
The remaining filter gets low. For further detail, see the instruction manual for the
projector.
57
Network information
On this window, click the [Network status] tab.