Table of Contents
Advertisement
Using the SD memory card in a Windows PC
The accessory PC card adapter can be used to insert the SD memory card
into a computer with a built-in PC (PCMCIA) card slot which is either Type II
or Type III compatible. The accessory JPEG Convertor software can then be
used to edit and save images onto the card.
Inserting the SD memory card
# # # # # Insert the SD memory card into the PC
card adapter as shown in the
illustration at right.
Push the card in until it locks into place.
Make sure that it is facing the correct way.
Note:
B If the SD memory card is inserted into a computer using the PC card
adapter while the write-protect switch is at the LOCK position, a blue
warning screen will be displayed when the computer attempts to access
the card. If this happens, press any key on the computer's keyboard to
clear the error display. Check that the write-protect switch is not at the
LOCK position when using the SD memory card in a computer.
$ $ $ $ $ Insert the PC card adapter into the PC card slot of the computer.
% % % % % If using the SD memory card for the first
time on a computer running Windows, the
Add New Hardware Wizard will start. Click
Next.
Note:
B When using the SD memory card for the
second time onwards, the following setting
steps are not necessary.
& & & & & Select "Display a list of all drivers in a
specific location, so you can select the
driver you want." and then click Next.
( ( ( ( ( Select "Standard IDE/ESDI Hard Disk
Controller" and then click Next.
Follow the prompts which appear on the
screen to continue with the installation. Lastly,
click End to finish.
PC card adapter
SD memory card
14
Advertisement
Table of Contents
