Table of Contents
Advertisement
Error messages on the display
If the unit detects a problem, one of the following messages will appear on the display.
ERROR MESSAGE
ADD PAPER
CHECK CARTRIDGE
CHECK COVER
CHECK DOCUMENT
CHECK MEMORY
INK EMPTY
INSTALL INK
MEMORY FULL
NO RESPONSE
OVERHEATED
PAPER JAMMED
PLEASE WAIT
POLLING ERROR
PRINTER ERROR
REMOVE DOCUMENT
TRANSMIT ERROR
WAITING PRINT
50
¡While printing, the unit ran out of recording paper. Install paper, and then press
the START/SET button.
¡The unit cannot control the cartridge or temperature sensor on the unit is
abnormal. Leave the unit for approx. 15 minutes and then press the START/SET
button.
¡The front lid is open. Close it.
¡The document is not fed into the unit properly. Reinsert the document and try
again. If misfeeding occurs frequently, clean the feeder rollers. If the problem
remains, adjust the feeder pressure. See the operating instructions for fax.
¡Memory (phone numbers, parameters, etc.) has been erased.
Re-program.
¡The print cartridge ran out of ink during fax reception. Replace the cartridge.
¡The print cartridge is not installed properly. Install it correctly.
¡When transmitting a document from memory, the document to be stored
exceeds the memory capacity of the unit. Turn off the memory transmission
feature or transmit the entire document manually.
¡The memory is full of received documents that have been stored in memory due
to a lack of recording paper, a recording paper jam or receiving in the printer
mode. Install paper or clear the jammed paper.
¡The receiving unit was busy or ran out of recording paper. Try again.
¡The temperature sensor in the print head of the print cartridge exceeds the
prescribed level or is abnormal. Leave the unit for approx. 15 minutes and press
the START/SET button.
¡A recording paper jam occurred. Remove the jammed paper.
¡The front lid is opened or closed, the printer mode is turned on or off, or a printer
error is reset. Wait for a while.
¡The other fax machine does not provide the polling function. Check the other
party.
¡Printer error occurred. Leave the unit for approx. 15 minutes and then press the
START/SET button to resume operation.
¡The document is jammed. Remove the jammed document.
¡Attempted to transmit a document longer than 600 mm (23
button and remove the document. Divide it into two or more sheets and try
again.
¡Transmission error occurred. Try again.
¡When the unit is in the printer mode, the fax documents sent by the other party
are stored in memory. To print them, turn the printer mode off.
CAUSE & REMEDY
w). Press the STOP
5
⁄
8
Advertisement
Table of Contents
