Before Using The Multi−Information Display; Switch Operation; Switches - Toyota 2007 Prius Owner's Manual

Before using
the multi−information display
27p178
Type 1 and Type 2
26p049b
Type 3
When the "ACC" mode is enabled, the
initial screen appears and the system be-
gins operating.
After a few seconds, the previous mode
display will appear.
If the electrical power source has been
disconnected from the multi−information
display, the display will be automatically
set to the initial mode.
CAUTION
Do not adjust the display while the
vehicle is moving. Be sure to adjust
the display only when the vehicle is
stopped.

Switch operation

This system operates mainly
switches on the screen. To protect the
screen, lightly touch

switches

screen with your finger. When you touch
a switch on the screen or on the bezel,
a beep sounds.
D
If the system does not respond to a
touch of a switch, move your finger
away from the screen and then touch
it again.
D
You cannot operate dimmed switches.
D
Wipe off fingerprints on the surface of
the display using a glass
cloth.
D
The displayed image may
darker and moving images may be
slightly distorted when the display is
cold.
D
When you look at the screen through
polarized material such as polarized
sunglasses, the screen may be dark
and hard to see. If so, look at the
screen from different angles, adjust the
screen settings on the
screen, or take off your sunglasses.
by the
on the
cleaning
become
"Display"
163