Toyota 2002 4runner Owner's Manual page 298

Replacing light bulbs—
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
D
To prevent yourself from burning,
do not replace the light bulbs while
they are hot.
D
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
280
'02 4Runner_U (L/O 0108)
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just
windshield fogged up in the rain. However,
if there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light,
Toyota dealer.
if
2002 MY 4RUNNER_U (OM35787U)
Light bulbs
Headlights
Front fog lights
Parking and front
like the
side marker lights
Front turn signal
lights
contact your
Rear turn signal
lights
Stop/tail lights
Back–up lights
License plate lights
High mounted
stoplight
Interior light
Personal lights
Glove box light
Luggage
compartment light
A: HB2 halogen bulbs
B: H3 halogen bulbs
C: Wedge base bulbs (clear)
D: Wedge base bulbs (amber)
E: Double end bulbs
Bulb
W Type
No.
— 60/55 A
— 55 B
— 5 C
— 21 C
— 21 D
— 21/5 C
— 18 C
— 5 C
921 18 C
— 8 E
— 8 E
— 1.4 C
— 8 E