Driving System - Mercedes-Benz 2013 GL X166 Operator's Manual

Driving systems
190
lose control of the vehicle. If the gradient is
too steep for your vehicle, drive back down in
reverse gear.
Maximum gradient-climbing capability
On good road surfaces the maximum
gradient-climbing capability of your vehicle is
100%, which corresponds to an approach/
departure angle of 45°. Note that the
vehicle's gradient-climbing capability
depends on the off-road conditions.
Accelerate carefully and make sure that the
wheels do not spin when driving on steep
terrain.
i If the load on the front axle is reduced
when pulling away on a steep uphill slope,
the front wheels have a tendency to spin.
4ETS recognizes this and brakes the
wheels accordingly. The rear wheel torque
is increased, making it easier to drive off.
Hilltops
When driving up an uphill gradient, slightly
reduce pressure on the accelerator
immediately before reaching the brow of the
hill. Use the vehicle's own impetus to drive
over the top of the hill.
This style of driving prevents:
the vehicle from lifting off the ground on the
R
brow of a hill
the vehicle from traveling too quickly down
R
the other side
Driving downhill
Drive slowly.
R
Do not drive at an angle down steep
R
inclines. Steer into the line of fall and drive
with the front wheels aligned straight.
Otherwise, the vehicle could slip sideways,
tip and rollover.
Before tackling steep downhill gradients,
R
select shift range 1.
Activate DSR. If this is not sufficient, brake
R
gently. When doing so, make sure that the
vehicle is facing in the direction of the line
of fall.
Check that the brakes are working normally
R
after a long downhill stretch.
i
The special off-road ABS setting enables
a precise, brief and repeated locking of the
front wheels. This causes them to dig into
loose earth. Be aware that the front wheels
easily skid across the ground surface if
completely braked and therefore lose their
ability to steer.
Driving systems
Cruise control
Important safety notes
G
WARNING
The cruise control is a convenience system
designed to assist the driver during vehicle
operation. The driver is and must always
remain responsible for the vehicle's speed
and for safe brake operation.
Only use the cruise control if the road, traffic,
and weather conditions make it advisable to
travel at a constant speed.
The use of the cruise control can be
R
dangerous on winding roads or in heavy
traffic because conditions do not allow safe
driving at a constant speed.
The use of the cruise control can be
R
dangerous on slippery roads. Rapid
changes in tire traction can result in wheel
spin and loss of control.
Deactivate the cruise control when driving
R
in fog.
The "Resume" function should only be
operated if the driver is fully aware of the
previously set speed and wishes to resume
this particular preset speed.
G
WARNING
The cruise control brakes automatically so
that the set speed is not exceeded.