Programming Other Devices - Toyota 2011 Tundra Owner's Manual

3-8. Other interior features
Press and hold the vehicle's programmed HomeLink
for 2 seconds and release it. Repeat this step once again. The
garage door may open.
If the garage door opens, the programming process is complete. If
the door does not open, press and release the button a third time.
This third press and release will complete the programming process
by opening the garage door.
The ceiling mounted garage door opener motor should now recog-
nize the HomeLink
Repeat the steps above to program another rolling code sys-
tem for any of the remaining HomeLink
Programming an entry gate (for U.S.A. owners)/Programming
n
all devices in the Canadian market
Place your transmitter 1 to 3 in. (25 to 75 mm) away from the
surface of the HomeLink
Keep the indicator on the HomeLink
Press and hold the selected HomeLink
Repeatedly press and release (cycle) the device's remote
control button for two seconds each until step 4 is completed.
When the indicator on the HomeLink
start to flashing rapidly, release the buttons.
Test the operation of the HomeLink
programmed button. Check to see if the gate/device operates
correctly.
Repeat the steps above to program another device for each of
the remaining HomeLink
n

Programming other devices

To program other devices such as home security systems, home
door locks or lighting, contact your authorized Toyota dealer for
assistance.
506
®
transceiver and operate the garage door.
®
.
®
®
buttons.
®
buttons.
in view while programming.
®
button.
®
compatible transceiver
®
by pressing the newly
®
button