Honda 1994 Accord Coupe Owner's Manual page 90

Audio System
Cassette Search Functions
Once a cassette is playing, you can
use the FF, REW, TMS, or REPEAT
function to look for desired songs or
passages.
To rewind the tape, push the F F /
REW/TMS switch down then
release it. You will see REW in the
display. To fast forward the tape,
push the switch up then release it.
You will see FF displayed. To stop
rewind or fast forward, press the
PLAY button. If the system reaches
the end of the cassette while in fast
forward or rewind, it automatically
stops that function, reverses
direction, and begins to play.
Press the REPEAT button to replay
the current passage. You will see
RPT displayed. When the system
reaches the end of the song or
passage that is being played, it
automatically goes into rewind.
When it senses the beginning of that
passage, it goes back to play. The
Comfort and Convenience Features
system will continue repeating this
passage until you turn off REPEAT
by pressing the button again.
The TMS function lets you skip to
the beginning of a song or other
passage. The tape skips forward or
backward, depending on which
direction you push the FF/REW/
TMS switch.
Activate TMS by pushing the F F /
REW/TMS switch and holding it
until you hear a beep. If you push the
switch down, you will see REW
blinking in the display as the tape
rewinds. If you push the switch up,
you will see FF blinking in the
display as the tape fast forwards.
When the system senses a silent
period on the tape, it goes back to
PLAY mode.
The REPEAT and TMS functions
use silent periods on the tape to find
the end of a selection. These
features may not work satisfactorily
on tapes that have almost no gap
between songs, a high noise level
between songs, or silent periods in
the middle of songs.
Caring for Cassettes
Damaged cassettes can jam inside
the drive or cause other problems.
See page 98 for information on
cassette care and protection.