Display Menu - Yamaha ysp-900 Owner's Manual

DISPLAY MENU

Use to manually adjust various parameters related to the
display.
SET MENU → MANUAL SETUP → DISPLAY MENU
4 DISPL Y MENU
)DIMMER SET
B)OSD
C)UNIT
[ ]/[ ]:Up/Down
[ENTER]:Enter
DIMMER SET (Dimmer settings)
Use to adjust the brightness of the front panel display.
A)DIMMER ET
. TANDARD DIMMER
AUTO DIMMER
[ ]/[ ]:Up/Down [ ]/[ ]: el
[ENTER]:Return
STANDARD DIMMER (Standard dimmer)
Use to adjust the brightness of the front panel display
when you operate this unit by using the control buttons on
the front panel or on the remote control.
Choices: –2, –1, OFF
AUTO DIMMER (Auto dimmer)
If no operation is performed for a specified period, the
front panel display dims. Use to adjust the brightness of
the front panel display in this case.
Choices: OFF (the same brightness as the STANDARD
DIMMER setting), –1 to –3 (based on the
STANDARD DIMMER setting), DISPLAY OFF
SET
SET
OFF
OFF
p
OSD SET (OSD settings)
Use to adjust the display position and the background
color of the OSD.
B) SD
. SD SHIFT
SD BACK C L R
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
OSD SHIFT (OSD shift)
Use to adjust the vertical position of the OSD. Adjust
towards the – (minus) direction to raise the position of the
OSD, and adjust towards the + (plus) direction to lower it.
Choices: –5 to +5
Initial setting: 0
OSD BACK COLOR (OSD background color)
Use to select the background color of the OSD.
Choices: BLUE, GRAY
UNIT SET (Unit settings)
Use this to change the display unit of measurement.
Choices: METERS, FEET
C)UNIT SET
ETERS
[ ]/[ ]:Select
[ENTER]:Return
• Select METERS to input distances in meters.
• Select FEET to input distances in feet.
Note
If you change this setting, the adjusted beam settings may change.
MANUAL SETUP
SET
0
BLUE
p
FEET
67
En