Yamaha RX-V1800 Owner's Manual page 21

Connecting the banana plug
(Except U.K., Europe, Asia and Korea
models)
1
Tighten the knob using the supplied speaker
terminal wrench.
Speaker terminal wrench
Red: positive (+)
Black: negative (–)
2
Insert the banana plug connector into the
end of the corresponding terminal.
y
You can also use the banana plug with the SP2 speaker terminals.
Open the tab and then insert one banana plug into the hole on the
terminal. Do not close the tab after connecting the banana plug.
Banana plug
Using bi-amplification connections
Caution
Remove the shorting bars or bridges of your speakers to
separate the LPF (low pass filter) and HPF (high pass filter)
crossovers.
This unit allows you to make bi-amplification connections
to one speaker system. Check if your speakers support bi-
amplification connection.
To make the bi-amplification connections, use the FRONT
and SURROUND BACK/BI-AMP speaker terminals as
shown below. To activate the bi-amplification connections,
set "BI-AMP" to "ON" in "ADVANCED SETUP" (see
page 116).
This unit
SURROUND BACK/
R
+
R
+
R
+
Right
Front speakers
Note
When you make the conventional connection with the speakers,
make sure that the shorting bars are put into the terminals of the
speakers appropriately. Refer to the instruction manuals of the
speakers for details.
Connections
L
BI-AMP
+
SINGLE
L
SURROUND
+
L
FRONT
+
Left
19
En