Panasonic CF-T2 Series Operating Instructions Manual page 28

Reinstalling Software
CAUTION
Do not interrupt the reinstall procedure before
completion, for example by turning off the com-
puter or pressing Ctrl + Alt + Del , as this
may prevent Windows from starting up, or may
cause data to be lost so that the reinstall procedure
cannot be executed.
When a message appears instructing you to insert
the next CD, insert the recovery CD showing the
next number in the sequence, and then select [OK].
If the message "The media does not contain the cor-
rect file" appears, select [OK]. A message will ap-
pear instructing you to insert the next CD.
Confirm that the proper recovery CD has been in-
serted by opening the cover of the CD drive and
then close the cover, then select [OK].
After the reinstallation procedure completes, this
screen should appear.
Windows XP
--------------------------------------------------------------------------
[Recovery] is complete.
Windows(R) XP Professional install wizard will start after reboot.
After turning off the power, please disconnect the CD/DVD-ROM drive, and
turn the power on again.
--------------------------------------------------------------------------
Windows 2000
--------------------------------------------------------------------------
[Recovery] is complete.
Windows(R) 2000 Professional install wizard will start after reboot.
After turning off the power, please disconnect the CD/DVD-ROM drive, and
turn the power on again.
--------------------------------------------------------------------------
Remove the recovery CD and press any key to shut
down the computer, then remove the CD drive.
Turn the computer on, and press F2 while [Panasonic]
screen is displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Pass-
word.
Press F9 .
At the confirmation message, select [Yes] and press
Enter . (The Setup Utility settings will return to their
default values. Even the security settings with the ex-
ception of the password(s) will return to their default
values.)
Press F10 .
At the confirmation message, select [Yes] and press
Enter .
Perform the setup procedure for Windows by following
the instructions on the screen (
Install the Acrobat Reader (
Run the Setup Utility and change the settings where nec-
essary.
28
page 11).
page 13).