Table of Contents
Advertisement
Alarm call reception
ONE TOUCH DIAL
1
STEP 1
DIAL
QUICK
ESC
MENU
TELE
The ALARM DIAL dialog appears when the unit accepts an
alarm call.
VIDEO1
Trans.01
ALARM DIAL JAN.01.01 00:00:00
1. Press the ALM ACK button to display images sent from
the alarm activated site. The alarm call disconnects
when the preset time in the transmitter elapses before
pressing the ALM ACK button.
2. Press the ALM ACK button again to clear the ALARM
DIAL dialog.
Automated Reception
1. The unit receives a call automatically.
2. Hold down the DIAL button for 2 seconds to terminate
the call.
60
Remote Controller WV-CU20
SWITCH
VIDEO
ALM ACK
2
3
4
5
SITE
AUTO/MANU
STEP 2
STEP 3
CALL
1
2
3
REDIAL
4
5
6
7
8
9
PRESET
SET
DELETE
0
#
AUDIO MUTE
ENTER
WIDE
AF
NEAR
FAR
JAN.01.01 00:00:00
ALARM
NO.1
Operations During Communica-
tion
Other than calling and receiving, the following operations
are available in the Control site during communication.
Changing View Points during SEQ
SCAN (sequential scan)
The sequential scan traces the preset view points one after
another with the dwell time preset in the 470 SEQUENTIAL
SCAN menu for the transmitter. View points are set up in
the 430 VIDEO SWITCH SETUP, including the camera num-
ber, preset position, trigger output assignment and alarm
ON/OFF.
ONE TOUCH DIAL
1
2
STEP 1
DIAL
1
QUICK
4
1
7
PRESET
ESC
MENU
TELE
WIDE
The sequential scan begins with the start view point and
goes to the next view point every time the preset dwell time
elapses on the Remote site.
On the Control site, the view point image is displayed on
the monitor sequentially during communication.
1. See the next page for changing the video input, preset
position, pan/tilt control, zoom and focus control. The
sequence may also be interrupted with an alarm call.
The interrupted sequence will resume when the restart
time set in the 470 menu elapses.
2. To halt the sequence step, press the AUTO/MANUAL
(#4 of the one-touch) button. The current view point will
be displayed until the AUTO/MANUAL button is
pressed again.
Remote Controller WV-CU20
2
SWITCH
VIDEO
ALM ACK
3
4
5
SITE
AUTO/MANU
STEP 2
STEP 3
CALL
2
3
REDIAL
5
6
8
9
SET
DELETE
0
#
AUDIO MUTE
ENTER
AF
NEAR
FAR
Advertisement
Table of Contents
