Speaker Installation Option - Panasonic SC-BTX75 Operating Instructions Manual

Optional speaker settings
Speaker check
1 Select "Test" and press [OK].
A test signal is output.
Front (L) Front (R)
,)
2 Press [OK].
The test signal stops.
≥No signal is output for the subwoofer. To adjust its volume,
see page 18, Adjusting speaker level during play.
To finish the speaker setting
Press [3, 4, 2, 1] to select "Complete" and press [OK].

Speaker installation option

Attaching to a wall
You can attach all of the speakers (except subwoofer) to a wall.
≥The wall or pillar on which the speakers are to be attached should be capable of supporting 10 kg per screw. Consult a qualified building
contractor when attaching the speakers to a wall. Improper attachment may result in damage to the wall and speakers.
Preparation
Remove the speaker bases.
BTX77
1 Remove the screw from the speaker.
2 Remove the speaker base.
1 Drive a screw (not included) into the wall.
At least 30 mm
4.0 mm
Wall or pillar
5.5 mm to 7.5 mm
2 Fit the speaker securely onto the screw(s) with the hole(s).
e.g., [BTX77] Front speaker
DO NOT
≥In this position, the speaker
will likely fall if moved to the
left or right.
Preventing the speakers from falling
≥You will need to obtain the appropriate screw eyes to match
the walls or pillars to which they are going to be fastened.
≥Consult a qualified housing contractor concerning the
appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support. Improper
attachment may result in damage to the wall or speakers.
≥Use a string of less than ‰ 2.0 mm, which is capable of
supporting over 10 kg.
BTX75
7.0 mm to 9.4 mm
DO
≥Move the speaker so that
the screw is in this position.
e.g.,
Front speakers
BTX77
A 97 mm
B 210 mm to 212 mm
C 48.5 mm
To avoid speaker dropping
e.g., [BTX77] Front speaker
String (not included)
Less than 10 cm
Rear of the speaker
≥Consult a qualified building contractor to avoid damage to the
wall or speakers.
≥Use a string of less than ‰ 2.0 mm, which is capable of
supporting over 10 kg.
e.g. [BTX77]
Screw eye
(not included)
Rear of the speaker
L
dB
Complete
Test 0
Test
BTX75
Screw eye
(not included)
String (not included)
Thread from the wall to the
speaker and tie tightly.
Approx.
150 mm
Wall
R
SW
VQT2Q72
39