Fixing Cooker Hood; Connection Of Exhausted Pipe - Siemens LC35S955 Operating And Installation Manual

Installation Instruction

Fixing Cooker Hood

Connection of
Exhausted Pipe
Maximum 1.65 m
Ø
175mm
纸张大小： 16 开（ 18.4 × 26 厘米）
Hang the cooker hood on to the fixing brackets on
the wall. Make sure the cooker hood does not
shake or hook off. Keep the cooker hood horizontal.
Install the accessory fixing screws in the notch as
shown in the figure to prevent the cooker hood
falling off from the mounting rails.
Each cooker hood is equipped with an exhausted
plastic pipe in a diameter of 175mm. The exhausted
pipe is 1.65m long when completely stretched.
Please connect one end of the exhausted pipe to
the outlet duct on the cooker hood and connect the
other end of the exhausted pipe to the common
chimney duct or the drilling hole in the external wall
(the diameter of the drilling hole is 180mm).
Common chimney duct
For optimum extractor hood efficiency:
1. Diameter of pipe should be as large as possible and
no tight bends in pipe.
2. The exhausted pipe can not be bent into a "凹"
shape (as few bends as possible).
3. Do not connect the exhausted pipe to another pipe
with a diameter smaller than 175mm.
4. Do not use a pipe with a diameter smaller than
175mm with an intermediate connecting pipe.
Directly discharge outside the wall
12