Sn12I Heat Pump Non-Programmable Thermostat; Installation And Operation Manual; Specifications; Features - Sea Breeze SN12I Installation And Operation Manual

SN12I HEAT PUMP NON-PROGRAMMABLE THERMOSTAT

SPECIFICATIONS

Power Supply:
Terminal Load:
Setpoint Temp. Range: 45º F to 90º F (7º C to 32º C)
Accuracy:
Dimensions:
Color:

FEATURES

•
Large LCD display with backlight, continuous backlight option
•
Independent heat and cool setpoints
•
Simultaneous display of room temperature, setpoint, and current time
•
Fan switch with ON and AUTO functions
•
Permanent user setting retention during power loss - no batteries are required*
•
Operates on 24VAC
•
Air filter service indicator
•
Low battery indicator
•
Temperature calibration
•
Configurable compressor short cycling protection
•
Compatible with 2 heat/1 cool heat pump systems with emergency heat
*Two "AA" batteries required to maintain clock function.

IMPORTANT SAFETY INFORMATION

•
Use a professional contractor to install this thermostat.
•
Read all of the information in this manual before installing this thermostat.
•
WARNING! Electrical Shock Hazard.
removing the fuse or switching the circuit breaker to the "OFF" position before installing,
removing, cleaning, or servicing this thermostat.
•
WARNING! Do not install on voltages higher than 30 VAC.
low-voltage thermostat.
•
All wiring must conform to local and national building and electrical codes and ordinances.
•
Do not short (jumper) across terminals on the gas valve or at the system control to test
installation. This will damage the thermostat and void the warranty.
•
Do not run the system in cooling if the outside temperature is below 50º F (10º C). This may
damage the air conditioning system.
•
Replace batteries when the low battery icon flashes.
• Clean or replace the air filter when "SERVICE FILTER" begins flashing.
•
Use this thermostat only as described in this manual.

Installation and Operation Manual

20VAC-30VAC 50-60HZ
1.0A per terminal, 3.0A maximum total load
+/- 1º F or +/- 0.5º C
6.0" W X 4.7" H X 1.1" D
White
Always turn off power at the main power source by
- 1 -
This is a 24VAC