HYOSUNG GT 250 R Service Manual page 31

6-28 CHASSIS
● Remove the handlebar clamp bolts.
● Remove the steering stem head nut ① and take off
the steering stem upper bracket ②.
● Remove the steering stem nut ③ and draw out the
steering stem.
Clamp wrench : 09940-10122
● Take off the steering stem lower bracket ④.
CAUTION
Hold the steering stem lower bracket by hand to
prevent from falling.
● Remove the upper and lower bearings ⑤.
● Remove the outer race fitted on the steering stem.
This can be done with a chisel.
● Draw out the two inner races fitted to the top and
bottom ends of the head pipe.
①
⑤
30
③
④
②