D-Link AirPlus DWL-900AP+ Manual page 15

Using the Configuration Menu (continued)
The illustration at right shows
the recommended default
setting (Disabled) for the
DHCP Server function of the
DWL-900AP+. If you wish to
use the DWL-900AP+ as a
DHCP server (not
recommended if you already
have a DHCP enabled
router/gateway on your
network) then select Enabled.
Enter the IP Address range
and click Apply, if you have
made any changes.
MAC Address
(Media Access
Control Address)
A unique
hardware address
that identifies a
device on a
network. It is
assigned at the
factory and
cannot be
changed. Usually
you will find this
address on a
sticker on the
device or on the
packaging.
The DWL-900AP+ can be configured to perform in any one of five modes, as a
wireless access point, as a point-to-point bridge with another access point, as a
point-to-multi-point bridge, as a wireless client, or as a wireless repeater.
Access Point: This mode is used to create a wireless LAN. Access Point is the
default setting.
Home > DHCP
Fig. 5.5
Advanced > Mode
Fig 5.6