Advertisement

Quick Links

Z A S T O N E
ZT-V900
IN S T R U C T IO N
M A N U A L
l

Advertisement

Table of Contents
loading

Summary of Contents for Zastone ZT-V900

  • Page 1 Z A S T O N E ZT-V900 IN S T R U C T IO N M A N U A L...
  • Page 2: Table Of Contents

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r CONTENTS P R E C A U T IO N S ................1 .........................
  • Page 3 .............. 1 0 e t t in g f f s e t ir e c t io n Q T / D Q T S .............1 0 e t t in g w it c h Q T / D Q T F ............
  • Page 4: R E Q U E N C

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r ..........o w e r is p l a y ..........o w e r a s s w o r d ...............
  • Page 5: Precautions

    r o f e s s io n a l H a n d h e ld T r a n s c e iv e r PRECAUTIONS a f e t y Please observe the following precautions to prevent the trans­ ceiver damaged: This device emits Radio Frequency (RF) energy.
  • Page 6: U N P A C K In G A N D C H E C K In G E Q U I P M E N T

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r ▲ If an abnormal odor or sm oke is detected coming from the transceiver, turn OFF the power immediately and remove the battery-pack from the transceiver.
  • Page 7: Key Features

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r Key Features » Full Frequency and 128 M em ory Channels »...
  • Page 8: Getting Acq Uainted

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r GETTING ACQ UAINTED...
  • Page 9: C H A R G In G B A T T E R Y

    h a r g in g a t t e r y Plug the battery or transceiver with battery into charger, and make sure the battery contact with charging terminal. When charging light turn red, charging has begin, and while the charging light turn green, charging has finished.
  • Page 10 r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r n s t a l l in g t h e n e n n a Screw the antenna into the connector on the top of the transceiver by holding...
  • Page 11: I O S / M

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r n s t a l l in g t h e p t io n a l p e a k e r ic r o p h o n e...
  • Page 12: Basic Transceiver Modes

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r Basic Transceiver Modes M o d e ( V F O ) r e q u e n c y is p l a y In this mode, you can use [ ( T ) ] / [ [ T } ] key or knob to change...
  • Page 13: Quick Function Operating

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r Setting Offset Func+5 No/+/- Direction Setting QT / DQT Func+6 Switch Select QT / DQT Func+7 QT / DQT Frequency...
  • Page 14: S E T T In G S T E P F R E Q U E N C

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r e t t in g t e p r e q u e n c y •...
  • Page 15: Q T S T A N D A R D

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r Q T S t a n d a r d r e q u e n c y a b l e 67.0 85.4...
  • Page 16: M E N U M O D

    r o f e s s io n a l H a n d h e ld T r a n s c e iv e r : V. n t e r t h e m e n u m o d e t h e s p e c if ic p l e a s e r e f e r e n u o d e...
  • Page 17: P O W E R O N D Is P L A

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r Menu Display and Description Content Setting Item Backlight control O FF/KEY/CONT Transceiver Lock Mode K+S/PTT/KEY/ALL ANI Code Switch...
  • Page 18 r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r Menu functions and setting (APO) A u t o m a t ic P o w e r If the APO function is turned on, the radio without any op­...
  • Page 19 r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r (BCLO) B u s y C h a n n e l L o c k O u t •...
  • Page 20: D Is P La Y S E L E C T Iv

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r ( L O C K ) r a n s c e iv e r o c k o d e Press [...
  • Page 21: P O W E R - O N P A S S W O R

    r o f e s s io n a l H a n d h e ld T r a n s c e iv e r • Display opening message o w e r a s s w o r d •...
  • Page 22: O X S E N S It Iv It Y

    r o f e s s io n a l F M H a n q h e l d r a n s c e iv e r S e n s it iv it y • Voice grade is lower, the higher the sensitivity Channel Setting t o r a g e h a n n e l...
  • Page 23: C H A N N E L I N It Ia L Iz In

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r • Press [ (T J ]/ [ [ r j ] to select M-ONLY Menu, and press[ (Kg ] to com plete setting.
  • Page 24: Fmr A D Io M E M O Ry C H A N N E L S T O R A G E

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r • Press [ [ X ] ]/ [ ( X ) ] key to change the radio frequency, also can be directly input the radio frequency with keypad.
  • Page 25: Ani Function

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r it, the screen only display the current working channel. 3. In dual standby mode, if one of the channels receives a signal, and the mark will point to the channel, indicating the channel is currently being edited.
  • Page 26: Specifications

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r SPECIFICATIONS VHF:136~174M Hz Frequency Range UHF:400~470MHz Memory Channel CTCSS/DCS 50 group CTCSS; 83*2 group DCS 5KH z,10KH z,12.5KH z,20KH z,25KH Step z,30KHz,50KHz,...
  • Page 27: W A Rr A Nty Card

    r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r W A RR A NTY CARD Buyer Name Telephone Address Dealer Telephone Address Model...
  • Page 28 r o f e s s io n a l F M H a n d h e l d r a n s c e iv e r N ote: 1. The product before sell all be tested and all passed. Use this warranty card for one year warranty, out of the warranty time repair will be asked charge.
  • Page 29 C ^ Z A S T C D N E tS±ll|BPBtaf4SWK&S) S H E N ZH E N ZA STO N E C O M M U N IC A T IO N TEC. CO.,LTD.

Table of Contents