Table of Contents
Advertisement
SETTINGS
Using the sound equalization
The adjustment is memorized for each source until
you adjust the sound again. If the source is a disc,
the adjustment is stored for each of the following
categories.
– DVD-Video
– CD/VCD/Audio files/Video files (Page 71)
You cannot adjust the sound when the AV source
is turned off.
Selecting a preset sound mode
1
Display the <Audio> screen. (Page 51)
2
Display the <Graphic Equalizer> screen.
You can also display the phone control screen
by selecting [
] on the pop-up short-cut
menu. (Page 11)
3
Display the preset sound modes (1), then
select a sound mode (2).
Touch [
] to hide the preset sound modes.
52
Storing your own adjustments—Adjusting the
sound precisely
1
Display the <Graphic Equalizer> screen.
(See the left column.)
2
Select a band and adjust the level of the
selected band.
You can adjust the level by dragging the slider
or using [J]/[K].
Repeat this step to adjust the level of other
bands.
3
Activate ([ON]) or deactivate ([OFF]) the
bass (<Bass EXT>) (1), and then adjust
the subwoofer level (<SW Level>)* (2).
Touch [H]/[I] to adjust <SW Level>.
When <Bass Ext> is set to [ON], a frequency
lower than 62.5 Hz is set to the same gain
level as 62.5 Hz.
4
Store the adjustment.
A user selection window appears. Select from
[User 1] to [User 4] to store your adjustment,
then touch [Close] to close the window.
To apply the adjusted equalizer to all playback
source, touch [ALL SRC] on the <Graphic
Equalizer> screen, then touch [OK] to confirm.
To make the current EQ curve flat, touch
[Initialize].
* Not adjustable when <None> is selected for subwoofer on the
<Speaker Select> screen. (Page 51)
Setting the crossover network mode
Select the appropriate crossover network mode
according to the speaker system (2-way speaker
system or 3-way speaker system).
1
Turn off the AV source. (Page 6)
2
Press
while holding volume + on the
monitor panel to display the <X'over
Network> screen.
3
Select the crossover network mode.
[2 way] Select this when connecting speakers
in a 2-way system (front/rear).
[3 way] Select this when connecting speakers
in a 3-way system (tweeter/mid
range/woofer).
A confirmation message appears. Press [Yes].
Hide quick links:
Advertisement
Table of Contents
