Output Settings - McIntosh C2600 Owner's Manual

RENAME: BAL 1
>MEDI <
Figure 13
RENAME: BAL 1
>MEDIA <
Figure 14
RENAME: BAL 1
>MEDIA <
Figure 15
RENAME: BAL 1
>MEDIA B <
Figure 16
RENAME: BAL 1
>MEDIA BR <
Figure 17
RENAME: BAL 1
>MEDIA BRD <
Figure 18
RENAME: BAL 1
>MEDIA BRDG <
Figure 19
20. To save the new name, press and hold in the IN-
PUT Control until "SETUP: MEDIA BRDG , ON
/ Rename" appears on the Front Panel Information
Display. Refer to figure 20.
SETUP: MEDIA BRDG
On / Rename
Figure 20
21. Exit the SETUP Mode by several presses of the
INPUT Control.
Note: For convenience, an "Input Assignment Chart"
on a separate sheet "Mc5A/5B" has been pro-
vided to keep track of changes.

Output Settings

The Output Settings provide the ability to change how
the C2600 Output 1, Output 2 and Headphones func-
tion.
OUTPUT 1 and 2:
By defaut OUTPUT 1 and 2 are set to go On/Off by
using the Front Panel OUTPUT 1 and 2 Push-buttons
or by using the OUTPUT 1 and 2 Push-buttons on the
Remote Control. If it is desirable to have OUTPUT 1
and/or 2 always On regardless of the OUTPUT 1 and
2 Push-button settings, perform the following:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until "SETUP: Out-
puts, (Hold INPUT)" appears on the Information
Display. Refer to figure 21.
SETUP: Outputs
(Hold INPUT)
Figure 21
3. Press and hold in the INPUT Control until
"SETUP: OUTPUT 1, Switched" appears on the
Display. Refer to figure 22.
SETUP: OUTPUT 1
Switched
Figure 22
4. Rotate the VOLUME (ADJUST) Control to change
from the "Switched" setting to "Unswitched".
Refer to figure 23.
SETUP: OUTPUT 1
Unswitched
Figure 23
5. In a similar manner, perform steps 3 and 4 to
change the OUTPUT 2 setting. Refer to figures 24
and 25 on the next page.
Setup, con't
15