Table of Contents
Advertisement
6.
If Use the following IP address is selected, write down the
information displayed in the box: the IP address, subnet mask, and
default gateway.
You will need these addresses to put back your computer in its initial
state once the configuration process is completed.
7.
If Obtain an IP address automatically is selected, click Use the
following IP address.
8.
Enter the desired IP address, subnet mask, and default gateway (the
temporary values when you are starting the configuration procedure,
or the initial values when the work is over).
9.
Click OK to close all windows.
To set the initial network parameters:
1.
Ensure that the device is powered and connected to the Ethernet
network.
2.
Write down the serial number of the device in a safe place.
3.
Start SConfigurator by double-clicking
hard disk. The SConfigurator window appears.
Verint Video Intelligence Solutions
Nextiva S4300-RP Installation Guide
SConfigurator.exe
on your
33
Advertisement
Table of Contents
