Advertisement
●
To change dies remove the cutting
assembly. Always hold the edge of
the cutting assembly in one hand
and twist the clamp ring towards you
and remove. Remove the securing
nut (use the spanner/pusher to
loosen the securing nut if necessary)
and switch on briefly to eject the die.
Remove the die and any visible
excess pasta and then fit the desired
die. Replace the securing nut and
cutting assembly.
warning
The pasta maker will get hot in use –
this is normal and is caused by the
pasta being compressed in the
attachment.
●
If the machine stalls or jams during
use, switch off. Depress the reverse
switch for a few seconds to release
the clogged pasta. Unplug and
remove any clogged material.
NOTE
The dies are specially made from a
bronze material to give the pasta a
rough textured surface to hold pasta
sauce for an authentic full flavour.
cleaning
Don't wash any part in the
dishwasher.
dismantle the attachment
●
Always hold the edge of the cutting
assembly in one hand and twist the
clamp ring towards you and remove.
Remove the securing nut, use the
spanner/pusher to loosen the
securing nut if necessary. Remove
the attachment from the machine by
turning the locking screw anti-
clockwise and pulling off the
attachment. Dismantle the parts.
dies
The Maccheroni rigati, Maccheroni
lisci and Bucatini dies can be pulled
apart to assist with the cleaning
process
.
●
Clean immediately after use,
otherwise the pasta will dry and be
extremely difficult to remove. Use the
cleaning tool to remove all the pasta
from the dies. The thicker end of the
tool is ideal for cleaning the larger
holes on the Maccheroni rigati die,
whilst the thinner end is suitable for
cleaing other dies. Wash in hot
soapy water, then dry thoroughly.
scroll
●
Do not immerse in water.
●
Wipe clean, then dry.
hopper, ring nut, body,
spanner, cutting assembly.
●
Remove any pasta dough and if
necessary wash in hot soapy water,
then dry thoroughly.
service and customer
care
●
If the cord is damaged it must, for
safety reasons, be replaced by
Kenwood or an authorised Kenwood
repairer.
UK
If you need help with:
●
using your pasta maker or
●
servicing, spare parts or repairs (in or
out of guarantee)
call Kenwood customer care on 023
9239 2333. Have your model
number ready – it's on the
underside of the power unit.
●
spares and attachments
call 0870 2413653.
●
other countries
Contact the shop where you bought
your machine.
4
Advertisement
