Advertisement
Advertisement
Table of Contents
Related Manuals for CANNICE Headblue 1
Summary of Contents for CANNICE Headblue 1
- Page 1 SMART HIFI WIRELESS HEADPHONE WITH TOUCH CONTROL INSTRUCTION Headblue 1...
-
Page 2: Start Here
Start here Following items are included USB cable... -
Page 3: Product Overview
Product overview 1.Volume down 2.Volume up 3.EQ button 4.Multifunction button 5.Trackback 6.Trackforward 7.LED indicator 8.Microphone 9.Charger connector... -
Page 4: Basic Operation
Basic operation Adjust the volume Press the "+" or "-" button to turn volume up or down, you hear beep voice prompts once reach the maximum or minimum. LED indicator and voice prompts Instruction LED status Voice prompts Power on Flashes blue twice Beep Power off... - Page 5 Pairing Pair one phone 1. Press and hold the multifunction button for about 5 seconds, the LED indicator flashes red and blue, you hear voice prompt tone from low to high. 2. Activate the Bluetooth feature on your phone, and set it to search for new Bluetooth devices.
- Page 6 3. Select “Headblue1”. If you phone asks, enter 0000 (four zeros) for the passcode or accept the connection. The LED indicator stops flashing red and blue once successfully paired. Note:When the headphone and phone have been paired once, they will automatically connect when the headphone is on and Bluetooth is activated on the phone.
-
Page 7: Pair Another Phone
Pair another phone Multipoint technology enables you to pair another phone and take a call from either. To pair with another mobile phone, follow the steps for “Pair One Phone”. After pairing successfully, restart the headphone to connect to 2 paired mobile phone automatically. Bluetooth Bluetooth Headblue1... - Page 8 Call Answer a call Press the multifunction button once. When call rings,the LED indicator flashes blue continuously, you hear voice prompt of continuous tone. End a call Press the multifunction button once. Reject a call Press the multifunction button for 2 seconds. When call rings,the LED indicator flashes blue continuously, you hear voice prompt of continuous tone.
- Page 9 Music (Need media player support) Music play / pause Press multifunction button to play / pause music. (Some phones may require you to start a media player first), you hear "toot" once. Trackback Press "<<" button to skip track backward, you hear "toot" once. Trackforward Press ">>"...
- Page 10 Rewind Press and hold “<<” button until begins to rewind. When you want to resume normal playback, release the “<<” button. EQ setting Press the EQ button to cycle through EQ setting: original, bass, treble, rock, pop. Note: the default EQ setting is original, the EQ setting will be restored to default once headphone restart.
-
Page 11: More Features
More features Voice dial (Need phone support.) Press the multifunction button for 2 seconds, you hear "toot", wait for phone prompt and then tell the phone to dial the name of a stored contact. Battery indicator The current battery status of headphone will be displayed in top right corner after the headphone connected to iOS devices. - Page 12 Listen music via USB cable (Microphone is disabled in this mode) 1. Connect the headset to a USB slot of PC using the supplied micro-USB cable. 2. The driver may need to be installed for the first time, after the driver installed successfully, sets “headphones CSR8645”...
- Page 13 Charging Your new headphone has enough power to pair and make a few calls. When battery is low, you will hear the warning tone. It takes 2.5 hours to fully charge the headphone. While charging, the battery indicator light is red, the indicator light flashes blue once charging is complete.
-
Page 14: Hardware Reset
Clear paired list Turn off the headphone, press and hold the multifunction button and EQ button simultaneously, then connect the headphone to a USB charger or USB port of computer, LED indicator flashes red, release multifunction button and EQ button after 4 seconds, paired list is cleared.