Panasonic SJ-MJ88 Service Manual page 29

4. Press the
LCD).
5. Set the laser power at 600
remote controller.
[Specified range: 600
Caution:
Proceeding on to the subsequent adjustment procedure with the read power
exceeding 600
6. Set the laser power with the
to "LDOK " in the LCD).
7. Press the
the LDC.
8. Remove the laser power meter. Laser power adjustment is finished.
[REFERENCE]
<For use of MD cartridge type laser power meter>
We recommend you to use a sensor type laser power meter for laser power
adjustment of this set.
But if available is a MD cartridge type only, follow the procedure below.
1. Disassemble the unit so that only the mechanism unit and the printed circuit
board are exposed. (as shown in
2. Set the laser power meter cartridge. (as shown in
3. Set the battery and attach and secure the battery cover with a rubber band.
(as shown in Fig. 9
4. Follow the steps for "6.2.1. Enter the adjustment mode". (Subsequent
procedures are the same as those for the sensor type.)
key of the remote controller ("LD " changes to "LP " of the
W±10% by using VOL+ and VOL- key of the
W±10%]
W±10% will result in damage to the optical pickup.
key of the remote controller ("LDOK " changes to "T0E " on
)
key of the remote controller ("LP " changes
Fig. 8 )
Fig. 8
Fig. 8
29
)