Description Of The Controls - Dometic B2600 Operation, Maintenance And Installation Manual

1 general informations

1.5.Description of the controls

GB
Remote control (B2200 B1600PLUS B2600)
REMOTE CONTROL
Operation Mode
Display Window
Timer
Clock Display
Set Point
Fan Speed Display
UP (+)
Down (-)
Clock
F°/C°
Light
Set
Room
Reset Button
* (only for models equipped with resistance) -
**(only for models equipped with light)
B1600 - B1600PLUS - B2200 - B2600
Low Battery
Room
Temperature
I Feel
Sleep
I FEEL I FEEL
ON/OFF
Fan
+
Mode
-
Timer
MODE
CLOCK
F°/C°
TIMER
LIGHT LIGHT
SLEEP
SET
I FEEL
ROOM
Sleep
I Feel
Press the ON/OFF button to start the airconditioner.
When it's OFF all the symbols are OFF, except the
clock and you can use the ROOM and the LIGHT
ON/OFF
buttons.
Choose the temperature measurement unit between
F°/C°
Celsius (°C) or Fahrenheit (°F).
If temperature is displayed this function is enabled.
F°/C°
Pressing the light key the light on the airconditioner dif-
LIGHT LIGHT
fuser is switched on (if equipped) .The light button works
LIGHT** also when the remote control is off.
Pressing this button the room symbol is displayed and
the local temperature is displayed instead the set point.
ROOM
Pressing the Room button an other time the Room
symbol disappear and the set point temperature is
ROOM
displayed instead the local one.
This button works also when the remote control is off.
Pressing the "CLOCK" button for a time longer than 2
seconds, it is possible to modify the "TIME SETTING",
CLOCK
managing the UP (+) button or the DOWN (-). Press
the "SET" button to confirm the modifications. After 15
CLOCK
seconds the new set is confirmed in any cases.
This button has two functions:
SET
1) To confirm the TIME SETTING
2) To resend the actual operating setting
SET
TIMER
Press this button to set the time of automatic startup
and/or shutdown.
TIMER
Press this button to activate the SLEEP function. The
SLEEP
set point is adjusted automatically to increase comfort
SLEEP when sleeping.
I FEEL
Every 10 minutes the operating set point is adjusted to
the temperature detected by the remote control.
I FEEL
The RESET button erases all the configuration parameters to default.
10
users ' instructions