Chain Lubricant; Filling Chain Oil Tank - Stihl MS 200 T Instruction Manual

Left: Bottom of cap twisted
Right: Bottom of cap correctly
positioned
N Place the cap on the opening and
rotate it counterclockwise until it
engages the filler neck.
N
Continue rotating the cap
counterclockwise (about a quarter
turn) – this causes the bottom of the
cap to be turned to the correct
position.
N Turn and lock the cap clockwise –
see sections on "Closing" and
"Checking security of cap".
MS 200 T

Chain Lubricant

For automatic and reliable lubrication of
the chain and guide bar – use only an
environmentally compatible quality
chain and bar lubricant. Rapidly
biodegradable STIHL Bioplus is
recommended.
Biological chain oil must be
resistant to aging (e.g. STIHL
Bioplus) since it will otherwise
quickly turn to resin. This results
in hard deposits that are difficult to
remove, especially in the area of
the chain drive, clutch and chain.
It may even cause the oil pump to
seize.
The service life of the chain and guide
bar depends on the quality of the
lubricant. It is therefore essential to use
only a specially formulated chain
lubricant.
Do not use waste oil. Renewed
contact with waste oil can cause
skin cancer. Moreover, waste oil is
environmentally harmful.
Waste oil does not have the
necessary lubricating properties
and is unsuitable for chain
lubrication.

Filling Chain Oil Tank

N Thoroughly clean the oil filler cap
and the area around it to ensure that
no dirt falls into the tank.
N Open the filler cap.
N Refill the chain oil tank every time
you refuel.
N Close the filler cap.
There must still be a small amount of oil
in the oil tank when the fuel tank is
empty.
If the oil level in the tank does not go
down, the reason may be a fault in the oil
supply system: Check chain lubrication,
clean the oilways, contact your dealer
for assistance if necessary STIHL
recommends that you have servicing
and repair work carried out exclusively
by an authorized STIHL servicing
dealer.
English
15