Factory Mode & Aging Mode - Philips HUDSON IV 150C5 Service Manual

http://jdwxzlw.com/?fromuser=华盛维修
Front View
How to enter Factory Mode
1. Turn off the monitor.
2. [Push "AUTO " & "OK" buttons at the same time and hold it
] + [Press power " " button until comes out "Windows screen"]
=> then release all button, then press
OSD menu with Characters HUDSON 150C5 V002 20040511
(below OSD menu) come on the Screen of the monitor
(see Fig. 2).
Factory Mode
---------->
HUDSON 150C5 V002 20040511
Indicator
Factory Menu
Cursor can move on gray color area
BL : Black level value
SUB- BRI : Brightness value range( Min Max)
SUB- CON : Contrast value range( Min Mid Max )
SRGB- B : Brightness of sRGB
SRGB- C : Contrast of sRGB
Gain- m : Minimum value of User Gain
Gain- M : Maximum value of User Gain
AUTO- SUB : To do Auto color function when push Menu key in white
pattern
OSD TIMER: OSD time out control(sec)
IDX : Limit current of inverter (CPT: 28) (LG:7)
Panel TYPE :PLS reference section 2.9.6
SCALER : Read/Write scaler register
Panel : HS (Hannstar panel)
CPT (CPT panel)
LG (LG. Philips panel)
家电维修资料网，免费下载各种维修资料
Factory Mode & Aging Mode
"OK" button , wait until the
HUDSON 150C5 V200 20040705
HS 1.LG (7) 2. CPT (28) 3. HS (28) 4. QDI (28)
How to Access Aging Mode
Step 1 : Turn off LCD monitor, and disconnect Interface Cable betwe-
en Monitor and PC.
Step 2 : [Push "AUTO" & " OK " buttons at the same time and hold it]
+[Press power " " button untill comes out " AGING screen"] =>
then release all buttons.
Bring up:
After 15 seconds,
bring up:
After 15 seconds,
bring up:
After 15 seconds,
bring up:
----------
----------
repeatly
Connect Signal cable again=> go back to normal display
150C5 LCD
Go to cover page
7
AGING...
AGING...
15